2011-2016 FJ Cruiser · Service Manual BRAKE

ABS Warning Light does not Come ON

Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 from Aug 2011

DESCRIPTION

If the ECU detects trouble, it illuminates the ABS warning light while at the same time prohibiting ABS control.
At this time, the ECU records a DTC in its memory.
Connecting terminals TC and CG of the DLC3 causes the ECU to display 2-digit DTCs by blinking the ABS warning light.

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK ABS WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Check that the ABS warning light comes on.

    OK:
    ABS warning light comes on.



NG
Go to step 2
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)

2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

  1. C135293E01
    Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A4-29 (WA) - E13-17 (ESC)
    Below 1 Ω
    A4-29 (WA) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← ABS Warning Light Remains ON (from Aug 2011)ABS Warning Light does not Come ON (Aug 2009 – Oct 2010) →