PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Jul 2014 from Aug 2014
- HINT:
- Use the table below to help determine the cause of the problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- If the malfunction still exists even after checking and confirming that all the circuits are normal, replace the A/C amplifier.
- Use the table below to help determine the cause of the problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| No Cool Air Comes Out: Compressor Not Operating |
Volume of refrigerant |
Click here
|
| Pressure switch |
Click here
|
|
| Magnetic clutch |
Click here
|
|
| Air conditioner amplifier assembly |
Click here
|
|
| Compressor pick up sensor |
Click here
|
|
| Cooler compressor assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| No Cool Air Comes Out: Blower Not Operating |
Blower resistor |
Click here
|
| Blower motor |
Click here
|
|
| Integration control and panel assembly |
Click here
|
|
| Air conditioner amplifier assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| No Cool Air Comes Out: Air Mix Damper Servo Not Operating |
Air mix control servo motor |
Click here
|
| Integration control and panel assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| No Cool Air Comes Out: Insufficient Cooling |
Volume of refrigerant |
Click here
|
| Blower motor performance check |
Click here
|
|
| Air mix damper servo full travel check |
Click here
|
|
| Recirculation damper servo operation check |
Click here
|
|
| No Engine Idle-up when A/C Switch ON |
Air conditioner amplifier assembly |
Click here
|
| Idling control system |
Click here
|
|
| Wire harness or connector |
- |
|
| No Warm Air Comes Out: Blower Not Operating |
Blower resistor |
Click here
|
| Blower motor |
Click here
|
|
| Integration control and panel assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| No Warm Air Comes Out: Air Mix Damper Servo Not Operating |
Air mix control servo motor |
Click here
|
| Integration control and panel assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| No Warm Air Comes Out: Insufficient Cooling |
Volume of engine coolant |
Click here
|
| Integration control and panel assembly |
Click here
|
|
| Blower motor performance check |
Click here
|
|
| Air mix damper servo full travel check |
Click here
|
|
| Recirculation damper servo operation check |
Click here
|
|
| Heater radiator unit sub-assembly |
- |
|
| Air Not Coming From Desired Outlets: Blower Not Operating |
Blower resistor |
Click here
|
| Blower motor |
Click here
|
|
| Integration control and panel assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| Air Not Coming From Desired Outlets: Air Mix Damper Servo Not Operating |
Air mix control servo motor |
Click here
|
| Wire harness or connector |
- |
|
| Windshield Fogging: Compressor Not Operating |
Volume of refrigerant |
Click here
|
| Magnetic clutch |
Click here
|
|
| NO. 1 cooler thermistor (evaporator temperature sensor) |
Click here
|
|
| Air conditioner amplifier assembly |
Click here
|
|
| Compressor pick up sensor |
Click here
|
|
| Cooler compressor assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| Windshield Fogging: Blower Not Operating |
Blower resistor |
Click here
|
| Blower motor |
Click here
|
|
| Integration control and panel assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| Windshield Fogging: Air Mix Damper Servo Not Operating |
Air mix control servo motor |
Click here
|
| Integration control and panel assembly |
Click here
|
|
| Wire harness or connector |
- |
|
| Windshield Fogging: Insufficient Cooling |
Volume of refrigerant |
Click here
|
| Blower motor performance check |
Click here
|
|
| Air mix damper servo full travel check |
Click here
|
|
| Recirculation damper servo operation check |
Click here
|
|
| Defrosting Insufficient: |
Blower motor |
Click here
|
| Mode doors: Check cooling, heating and door operation |
- |
|
| Mode control servo motor: Hot air not coming, Go to no warm air comes out |
- |
|
| Mode control servo motor: Cold air not coming, Go to no cold air comes out |
- |
|
| Noise: |
Blower motor: Inspect blower motor for debris/cracks |
- |
| Fresh air intake area: Inspect fresh air intake area for debris |
- |
|
| Noise: |
Cooler compressor: Cooler compressor incorrectly fitted |
Click here
|
| Magnetic clutch |
Click here
|
|
| Refrigerant charge amount |
Click here
|
|
| A/C lines secure and not grounded |
- |
|
| Odor (Cycle through blower speed, mode, temperature to define odor type when engine is running and A/C switch is ON. (Musty smell, coolant oil smell)) |
Wet carpet: Inspect for water, engine coolant or oil leaks |
- |
| A/C drain tube: Inspect for water, engine coolant or oil leaks |
- |
|
| Fresh air intake area: Inspect for water, engine coolant or oil leaks |
- |
|
| Heater hose: Inspect for water, engine coolant or oil leaks |
- |
|
| Evaporator: Inspect for water, engine coolant or oil leaks |
- |
|
| Evapo case: Inspect for water, engine coolant or oil leaks |
- |
|
| Air Not Coming from Desired Outlets (Cycle the mode lever and check airflow for outlets when engine is running, A/C switch is ON.) |
Blower motor |
Click here
|
| Mode control servo motor |
Click here
|
|
| Mode doors: Check cooling, heating and door operation |
- |
|
| Wire harness or connector |
- |
|
| Integration control and panel assembly |
Click here
|