Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Before performing verification listed in the table below, check the fuse and relay.
  2. Methods used to verify the cause of the problem are listed in order of probability in the suspected area column.


Audio function 
Symptom
Suspected area
See page
Pressing power switch does not turn on system.
1. Radio receiver power source circuit
Click here
2. Replace radio receiver
Click here
No sound can be heard from speakers (audio is mute).
1. Radio receiver power source circuit
Click here
2. Speaker circuit
Click here
3. Replace radio receiver
Click here
Sound quality is bad in all modes. (Volume is too low.)
1. Sound quality is bad in all modes (volume is too low)
Click here
2. Radio receiver power source circuit
Click here
3. Speaker circuit
Click here
4. Replace radio receiver
Click here
Abnormal noise occurs.
1. Noise occurs
Click here
2. Replace radio receiver
Click here
Radio broadcast cannot be received (poor reception).
1. Radio broadcast cannot be received (bad reception)
Click here
CD cannot be inserted/played or CD is ejected right after insertion.
1. CD cannot be inserted/played or CD is ejected right after insertion
Click here
CD cannot be ejected.
1. CD cannot be ejected
Click here
Sound quality is bad only when playing CD. (Volume is too low.)
1. Sound quality is bad only when CD is played (volume is too low)
Click here
CD sound skips.
1. CD sound skips
Click here
2. Replace radio receiver
Click here
Cassette tape cannot be inserted or played.
1. Cassette tape cannot be inserted or played
Click here
Cassette tape cannot be ejected.
1. Cassette tape cannot be ejected
Click here
Sound quality is bad only when playing tape.
1. Sound quality is bad when playing tape
Click here
Tape is tangled due to incorrect tape speed or auto-reverse malfunction.
1. Tape is tangled due to incorrect tape speed or auto-reverse malfunction
Click here
Radio receiver cannot be illuminated in night time.
1. Illumination circuit
Click here
2. Replace radio receiver
Click here