2014-2019 Hiace · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017


1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


2. REMOVE BRAKE MASTER CYLINDER

  1. C106096E02
    Using a union nut wrench, disconnect the 2 brake tubes from the master cylinder.

  1. Disconnect the warning switch connector.

  1. C112532
    for Manual Transmission:
    Slide the clip and separate the clutch reservoir tube.

  1. C106097
    Remove the 2 nuts, and disconnect the bracket.

  1. Remove the brake master cylinder from brake booster.


3. REMOVE HEADLIGHT ASSEMBLY RH (for RHD with Standard Body)

HINT:
Remove of the headlight assembly RH is the same as the headlight assembly LH.

  1. for Halogen Headlight:
    (Click here)

  1. for LED Headlight:
    (Click here)


4. REMOVE HEADLIGHT ASSEMBLY RH (for RHD with Wide Body)

HINT:
Remove of the headlight assembly RH is the same as the headlight assembly LH.

  1. for Halogen Headlight:
    (Click here)

  1. for LED Headlight:
    (Click here)


5. REMOVE RADIATOR GRILLE (for LHD with Standard Body)
(Click here)

6. REMOVE WINDSHIELD WASHER JAR ASSEMBLY (for LHD with Standard Body)
(Click here)

7. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER
(Click here)

8. SEPARATE MASTER CYLINDER PUSH ROD CLEVIS
  1. Remove the clip and clevis pin and separate the push rod clevis from the brake pedal.


9. SEPARATE BRAKE TUBE

  1. for Manual transmission:

    1. C113662
      Using a union nut wrench, disconnect the clutch tube from the clutch master cylinder.

    2. C106102
      Disengage the 3 tubes from the clamp.

  1. for Automatic transmission:
    Disengage the 2 tubes from the clamp.


10. REMOVE BRAKE BOOSTER ASSEMBLY

  1. C106100E02
    Slide the clip, disconnect the vacuum hose.

  1. for 2KD-FTV, 5L-E engine type:
    Disconnect the vacuum warning switch connector from the brake booster.

  1. C106101
    Remove the 4 nuts and brake booster assembly.


11. REMOVE BRAKE BOOSTER GASKET

12. DISCONNECT WIRE HARNESS

  1. C106112
    Disconnect the 2 connectors.


13. REMOVE ACCELERATOR PEDAL ROD ASSEMBLY

  1. C106094
    Remove the 2 nuts and accelerator pedal rod assembly.


14. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

  1. C102531
    Loosening the bolt.

    CAUTION:
    Do not remove the loosened bolt

    HINT:
    When loosening the nut, keep the bolt from rotating.

  1. C106095
    Remove the 5 bolts, nut and the brake pedal support assembly.

← COMPONENTS (from Oct 2014)REMOVAL (Jan 2015 – Dec 2016) →