2014-2019 Hiace · Service Manual BRAKE

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017


DESCRIPTION
When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the vehicle's skid control ECU (brake actuator assembly).
The skid control ECU (brake actuator assembly) records DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.
To check the DTCs, connect the GTS to the DLC3 on the vehicle. The GTS enables you to clear the DTCs, activate the various actuators, and check the Freeze Frame Data and Data List.
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge the battery before proceeding to the next step.

  2. Check the DLC3 (Click here).


DIAGNOSIS
  1. If a malfunction occurs in one part of the system, the skid control ECU (brake actuator assembly) illuminates the warning light corresponding to the malfunctioning system (ABS warning light, brake warning light or slip indicator light).

  2. The DTCs are simultaneously stored in memory.
    The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning and slip indicator lights, or by connecting the GTS (Click here).

  3. This system has a Test Mode (signal check) function (Click here).


WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
  1. Release the parking brake.

    NOTICE:
    When releasing the parking brake, move the shift lever to P (for Automatic Transmission) or set chocks (for Manual Transmission) to prevent the vehicle from rolling.

    HINT:
    When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.

  2. When the ignition switch is turned to ON, check that the ABS warning, brake warning, VSC OFF indicator, TRC OFF indicator and slip indicator lights illuminate, and then turn off after approximately 3 seconds.

    HINT:
    1. If a light does not illuminate, check the communication line between the combination meter assembly and skid control ECU (brake actuator assembly).
    2. If the ABS warning light or slip indicator light remains illuminated after approximately 3 seconds, check for DTCs and check the corresponding code. If no DTC is output, check the communication line between the combination meter assembly and skid control ECU (brake actuator assembly).

    Trouble Area
    See Procedure
    ABS warning light circuit (Remains on)
    Click here
    ABS warning light circuit (Does not come on)
    Click here
    Brake warning light circuit (Remains on)
    Click here
    Brake warning light circuit (Does not come on)
    Click here
    VSC OFF indicator light circuit (Remains on)
    Click here
    VSC OFF indicator light circuit (Does not come on)
    Click here
    TRC OFF indicator light circuit (Remains on)
    Click here
    TRC OFF indicator light circuit (Does not come on)
    Click here
    Slip indicator light circuit (Remains on)
    Click here
    Slip indicator light circuit (Does not come on)
    Click here

← DIAGNOSIS SYSTEM (Jan 2015 – Mar 2016)DIAGNOSIS SYSTEM (Jan 2017 – Nov 2017) →