2014-2019 Hiace · Service Manual BRAKE

C1203 ECM Communication Circuit Malfunction

Diagnostic trouble codes · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

DESCRIPTION

This circuit is used to send TRC and VSC control information from the skid control ECU (brake actuator assembly) to the ECM, and engine control information from the ECM to the skid control ECU (brake actuator assembly) via CAN communication.
DTC No.
DTC Detection Condition
Trouble Area
C1203
Either of the following is detected:
  1. Engine model information sent from the ECM does not match the information stored in the skid control ECU.
  2. No system information stored in the skid control ECU.
  3. Incorrect installation of the skid control ECU or ECM.
  1. ECM malfunction or ECM with incorrect part number installed
  2. Skid control ECU (Brake actuator assembly)

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click here).


1. CHECK PART NUMBER (ECM)
  1. Check that the proper ECM is installed.

    Result:
    Result
    Proceed to
    Proper ECM is installed
    A
    Proper ECM are not installed
    B


    HINT:
    Refer to the ECM removal procedures: 
    Item
    See page
    1KD-FTV
    Click here
    2KD-FTV
    Click here
    1TR-FE
    Click here
    2TR-FE (except Dual VVT-i)
    Click here
    2TR-FE (w/ Dual VVT-i)
    Click here



B
REPLACE ECM
A


2. CHECK BRAKE ACTUATOR ASSEMBLY
  1. Check if the brake actuator assembly had been replaced before the DTC was recorded.

    Result:
    Result
    Proceed to
    The brake actuator assembly is not replaced
    A
    The brake actuator assembly is replaced
    B



B
Go to step 4
A


3. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC C1203 is not output
    A
    DTC C1203 is output
    B



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)

4. PERFORM INITIALIZATION AND CALIBRATION
  1. Perform initialization and calibration (Click here).


NEXT


5. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC C1203 is not output
    A
    DTC C1203 is output
    B



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

END


← C1203 ECM Communication Circuit Malfunction (Jan 2015 – Mar 2016)C1203 ECM Communication Circuit Malfunction (Jan 2017 – Nov 2017) →