Refer to DTC P040A11.
Refer to DTC P054411.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>P054411
Refer to DTC P246E11.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P040A2A | Exhaust Gas Recirculation Temperature Sensor "A" Circuit Range/Performance Signal Stuck In Range | The change in the No. 5 exhaust gas temperature sensor (EGR gas temperature sensor) from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (EGR flow rate is equal to or greater than a fixed value for approximately 15 minutes) is small.
(2 trip detection logic) |
·
No. 5 exhaust gas temperature sensor (EGR gas temperature sensor) ·
ECM (soak timer) |
Class B2 | DTC stored | SAE Code: P040B |
| P05442A | Exhaust Gas Temperature Sensor 1 Bank 1 Signal Stuck In Range | The change in the exhaust temperature sensors from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (approximately 15 minutes) is small.
(2 trip detection logic) |
·
Exhaust gas temperature sensor ·
ECM (soak timer) |
Class B2 | DTC stored | SAE Code: P2080 |
| P20312A | Exhaust Gas Temperature Sensor 2 Bank 1 Signal Stuck In Range | The change in the No. 2 exhaust temperature sensors from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (approximately 15 minutes) is small.
(2 trip detection logic) |
·
No. 2 exhaust gas temperature sensor ·
ECM (soak timer) |
Class B2 | DTC stored | SAE Code: P2084 |
| P242A2A | Exhaust Gas Temperature Sensor 3 Bank 1 Signal Stuck In Range | The change in the No. 3 exhaust temperature sensors from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (approximately 15 minutes) is small.
(2 trip detection logic) |
·
No. 3 exhaust gas temperature sensor ·
ECM (soak timer) |
Class B1 | DTC stored | SAE Code: P242B |
| P246E2A | Exhaust Gas Temperature Sensor 4 Bank 1 Signal Stuck In Range | The change in the No. 4 exhaust temperature sensors from before the engine is started (after leaving the vehicle alone for 10 hours) and after driving for a fixed amount of time (approximately 15 minutes) is small.
(2 trip detection logic) |
·
No. 4 exhaust gas temperature sensor ·
ECM (soak timer) |
Class B1 | DTC stored | SAE Code: P246F |
| DTC No. | Data List |
|---|---|
| P040A2A
P05442A P20312A P242A2A P246E2A |
·
EGR Temperature B1S1 ·
Exhaust Temperature B1S1 ·
Exhaust Temperature B1S2 ·
Exhaust Temperature B1S3 ·
Exhaust Temperature B1S4 |
The No. 5 exhaust gas temperature sensor (EGR gas temperature sensor) is installed between the electric EGR control valve assembly and intake manifold.
Sensor 1 represents the sensor located upstream of the DOC catalytic converter.
Sensor 2 represents the sensor located upstream of the DPF catalytic converter.
Sensor 3 represents the sensor located downstream of the DPF catalytic converter.
Sensor 4 represents the sensor located downstream of the SCR catalyst.
If DTC P05442A, P20312A and/or P242A2A is stored, the following symptoms may appear:
White smoke
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P040A2A | Check the No. 5 exhaust gas temperature (EGR gas temperature) after leaving the vehicle for 1 to 2 hours and after driving*1 |
| P05442A | Check the exhaust gas temperature after leaving the vehicle for 1 to 2 hours and after driving*2 |
| P20312A | Check the No. 2 exhaust gas temperature after leaving the vehicle for 1 to 2 hours and after driving*2 |
| P242A2A | Check the No. 3 exhaust gas temperature after leaving the vehicle for 1 to 2 hours and after driving*2 |
| P246E2A | Check the No. 4 exhaust gas temperature after leaving the vehicle for 1 to 2 hours and after driving*3 |
*1: Drive the vehicle for 5 minutes or more at a speed of 100 km/h (62.5 mph) or more.
*2: Drive the vehicle for 5 minutes or more at a speed of 50 km/h (31.1 mph) or more.
*3: Drive the vehicle for 10 minutes or more at a speed of 50 km/h (31.1 mph) or more.
Refer to DTC P040A11.
Refer to DTC P054411.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>P054411
Refer to DTC P246E11.
After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>REGISTRATION) and initialization (Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Exhaust Gas Temperature Sensor for EGR)>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P040A2A, P05442A, P20312A, P242A2A or P246E2A is output | A |
| DTC P040A2A, P05442A, P20312A, P242A2A or P246E2A and other DTCs are output | B |
A
B
Leave the vehicle as is for 1 to 2 hours with the engine stopped.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Data List / Diesel Exhaust / EGR Temperature B1S1, Exhaust Temperature B1S1, Exhaust Temperature B1S2, Exhaust Temperature B1S3 and Exhaust Temperature B1S4.
| Tester Display |
|---|
| EGR Temperature B1S1 |
| Exhaust Temperature B1S1 |
| Exhaust Temperature B1S2 |
| Exhaust Temperature B1S3 |
| Exhaust Temperature B1S4 |
Record the exhaust temperature displayed on the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Drive the vehicle for 5 minutes or more at a speed of 50 km/h (31.1 mph) or more.
Stop the vehicle.
Connect the GTS to the DLC3.
Enter the following menus: Powertrain / Engine and Transmission / Data List / Diesel Exhaust / EGR Temperature B1S1, Exhaust Temperature B1S1, Exhaust Temperature B1S2, Exhaust Temperature B1S3 and Exhaust Temperature B1S4.
| Tester Display |
|---|
| EGR Temperature B1S1 |
| Exhaust Temperature B1S1 |
| Exhaust Temperature B1S2 |
| Exhaust Temperature B1S3 |
| Exhaust Temperature B1S4 |
Read the value.
| Result | Proceed to |
|---|---|
| Difference between EGR Temperature B1S1 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and EGR Temperature B1S1 checked after driving is within +/-15°C (27°F) | A |
| Difference between Exhaust Temperature B1S1 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and Exhaust Temperature B1S1 checked after driving is within +/-15°C (27°F) | |
| Difference between Exhaust Temperature B1S2 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and Exhaust Temperature B1S2 checked after driving is within +/-15°C (27°F) | |
| Difference between Exhaust Temperature B1S3 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and Exhaust Temperature B1S3 checked after driving is within +/-15°C (27°F) | |
| Difference between Exhaust Temperature B1S4 recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and Exhaust Temperature B1S4 checked after driving is within +/-15°C (27°F) | |
| Difference between exhaust temperature recorded in "READ VALUE USING GTS (EXHAUST TEMPERATURE)" and exhaust temperature checked after driving is equal to or greater than +/-15°C (27°F) | B |
A
B
Replace the exhaust temperature sensor that changed a small amount in "INSPECT EXHAUST GAS TEMPERATURE SENSOR".
Replace the No. 5 exhaust gas temperature sensor (EGR gas temperature sensor).
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>EXHAUST GAS TEMPERATURE SENSOR (for EGR)>REMOVAL
Replace the exhaust gas temperature sensor.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>EXHAUST GAS TEMPERATURE SENSOR>REMOVAL
Replace the No. 2 exhaust gas temperature sensor.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>EXHAUST GAS TEMPERATURE SENSOR>REMOVAL
Replace the No. 3 exhaust gas temperature sensor.
Click hereEngine / Hybrid System>1GD-FTV (EMISSION CONTROL)>EXHAUST GAS TEMPERATURE SENSOR>REMOVAL
Replace the No. 4 exhaust gas temperature sensor.
| Proceed to |
|---|
| NEXT |
NEXT
Leave the vehicle as is for 1 to 2 hours with the engine stopped.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Data List / Diesel Exhaust / EGR Temperature B1S1, Exhaust Temperature B1S1, Exhaust Temperature B1S2, Exhaust Temperature B1S3 and Exhaust Temperature B1S4.
| Tester Display |
|---|
| EGR Temperature B1S1 |
| Exhaust Temperature B1S1 |
| Exhaust Temperature B1S2 |
| Exhaust Temperature B1S3 |
| Exhaust Temperature B1S4 |
Record the exhaust temperature displayed on the GTS.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern
Stop the vehicle.
Connect the GTS to the DLC3.
Enter the following menus: Powertrain / Engine and Transmission / Data List / EGR Temperature B1S1, Exhaust Temperature B1S1, Exhaust Temperature B1S2, Exhaust Temperature B1S3 and Exhaust Temperature B1S4.
| Tester Display |
|---|
| EGR Temperature B1S1 |
| Exhaust Temperature B1S1 |
| Exhaust Temperature B1S2 |
| Exhaust Temperature B1S3 |
| Exhaust Temperature B1S4 |
Check the exhaust temperature after leaving the vehicle for 1 to 2 hours and after driving.
+/-15°C (27°F) or more
| Proceed to |
|---|
| NEXT |
NEXT
Replace the ECM.
Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT