The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front transmission bearing retainer oil seal removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
| *a | Object Exceeding Weight Limit of Transmission Jack |
The manual transmission assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop or a part may fall.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the systems is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.REMOVE MANUAL TRANSMISSION ASSEMBLY
31126
2.REMOVE CLUTCH RELEASE FORK BOOT (for 1GD-FTV)
Click hereDrivetrain>CLUTCH>CLUTCH UNIT>REMOVAL
31230
3.REMOVE CLUTCH RELEASE BEARING ASSEMBLY
Click hereDrivetrain>CLUTCH>CLUTCH UNIT>REMOVAL
31236B
4.REMOVE RELEASE FORK SUPPORT
Click hereDrivetrain>CLUTCH>CLUTCH UNIT>REMOVAL
31111
5.REMOVE CLUTCH HOUSING
33131D
6.REMOVE FRONT BEARING RETAINER
33124C
7.REMOVE NO. 1 OIL RECEIVER PIPE (MTM)
33131A
8.REMOVE FRONT TRANSMISSION BEARING RETAINER OIL SEAL
| *a | Protective Tape |
Using a screwdriver, pry out the front transmission bearing retainer oil seal.
Be careful not to damage the front bearing retainer.
Tape the screwdriver tip before use.
33131A
9.INSTALL FRONT TRANSMISSION BEARING RETAINER OIL SEAL
Using SST and a press, press in a new front transmission bearing retainer oil seal.
0.8 to 1.8 mm (0.0315 to 0.0708 in.)
Be careful not to damage the lip of the front transmission bearing retainer oil seal.
Apply MP grease oil to the lip of the front transmission bearing retainer oil seal.
33124C
10.INSTALL NO. 1 OIL RECEIVER PIPE (MTM)
33131D
11.INSTALL FRONT BEARING RETAINER
31111
12.INSTALL CLUTCH HOUSING
31236B
13.INSTALL RELEASE FORK SUPPORT
31230
14.INSTALL CLUTCH RELEASE BEARING ASSEMBLY
31126
15.INSTALL CLUTCH RELEASE FORK BOOT (for 1GD-FTV)
16.INSTALL MANUAL TRANSMISSION ASSEMBLY