Illumination Circuit
Circuit diagnosis · Vehicles built from Jul 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
DESCRIPTION
| w/ Multi-information Display: |
- HINT:
- If the automatic light control sensor has a malfunction, DTC B1244 is output. (Click here)
WIRING DIAGRAM
| w/ Multi-information Display: |


INSPECTION PROCEDURE
| 1. CONFIRM SYMPTOMS |
Confirm the symptom.
- Result:
Result
Proceed to
Only clock illumination has a malfunction.
A
Clock illumination, combination meter assembly illumination, and heater control panel illumination have a malfunction.
B
|
|
||||
| A | |
| 2. CHECK CAN COMMUNICATION SYSTEM |
Check if any DTC is output (Click here).
- Result:
Result
Proceed to
CAN communication DTC is not output.
A
CAN Communication DTC is output.
B
|
|
||||
| A | |
| 3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Ignition switch on (IG).
Turn the tester ON.
Enter the following menus: Body Electrical / Main Body / Active Test.
Check the clock illumination.
- Main Body:
Tester Display
Test Part
Control Range
Diagnostic Note
Dimmer Signal
Dimmer Signal
Dimmer signal is OFF/ON
Confirm that the vehicle is stopped, engine idling
- OK:
- The clock illumination is dimmed when the Dimmer signal is ON.
- HINT:
- Refer to the sensitivity setting in the customization table of the lighting system (Click here).
|
|
||||
| OK | ||
| ||
| 4. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - COMBINATION METER) |
Disconnect the E1 and E9 connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E9-9 (CLK) - E1-36 (MCLK)
Always
Below 1 Ω
E9-10 (DATA) - E1-37 (MDAT)
Always
Below 1 Ω
E9-11 (SYNC) - E1-38 (SYNC)
Always
Below 1 Ω
E1-36 (MCLK) - Body ground
Always
10 kΩ or higher
E1-37 (MDAT) - Body ground
Always
10 kΩ or higher
E1-38 (SYNC) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 5. INSPECT COMBINATION METER ASSEMBLY |
Reconnect the E1 connector.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E9-9 (CLK) - Body ground
Ignition switch on (IG), headlight dimmer switch TAIL or HEAD
Pulse generation
E9-10 (DATA) - Body ground
Ignition switch on (IG), headlight dimmer switch TAIL or HEAD
Pulse generation
E9-11 (SYNC) - Body ground
Ignition switch on (IG), headlight dimmer switch TAIL or HEAD
Pulse generation
E9-9 (CLK) - Body ground
Ignition switch on (IG), headlight dimmer switch OFF
Below 1 V
E9-10 (DATA) - Body ground
Ignition switch on (IG), headlight dimmer switch OFF
Below 1 V
E9-11 (SYNC) - Body ground
Ignition switch on (IG), headlight dimmer switch OFF
Below 1 V
|
|
||||
| OK | ||
| ||
