DTC C0278 Open in ABS Solenoid Relay Circuit |
DTC C0279 Short in ABS Solenoid Relay Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C0278 | Either of the following is detected:
|
|
| C0279 | Immediately after the ignition switch is turned on (IG), the solenoid relay contact is closed for 4 seconds when the relay is turned off. |
|
| 1.INSPECT VSC NO. 2 FUSE |
![]() |
Remove the fusible link block from the engine room relay block.
Check if the fusible link is melted.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| VSC NO. 2 (30 A) fuse - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.INSPECT SKID CONTROL ECU (+BS TERMINAL) |
![]() |
Install the fusible link block to the engine room relay block with the nut.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-12 (+BS) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU (GND1 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-1 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTCs (C0278 and C0279) are not output | A |
| DTCs (C0278 and/or C0279) are output | B |
|
| ||||
| A | ||
| ||