DTC C1427 Motor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1427 | Actuator pump motor does not operate properly. |
|
| 1.PERFORM ACTIVE TEST USING TECHSTREAM (ABS MOTOR RELAY) |
Connect Techstream to the DLC3.
Start the engine.
Select the Active Test mode on Techstream (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | ABS motor relay | Relay ON / OFF | Operating sound of motor can be heard |
Check for operating sound of the ABS motor relay when operating it with Techstream.
| Result | Proceed to |
| Operating sound is not heard | A |
| Operating sound is heard | B |
|
| ||||
| A | |
| 2.INSPECT SKID CONTROL ECU (GND2 TERMINAL) |
![]() |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-13 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC (C1427) is not output | A |
| DTC (C1427) is output | B |
|
| ||||
| A | ||
| ||