DTC C1210 Zero Point Calibration of Yaw Rate Sensor Undone |
DTC C1336 Zero Point Calibration of Acceleration Sensor Undone |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1210 | Zero point calibration of yaw rate sensor undone. | Yaw rate and acceleration sensor |
| C1336 | Zero point calibration of acceleration sensor undone. | Yaw rate and acceleration sensor |
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR |
Perform zero point calibration of the yaw rate and acceleration sensor (Click here).
| NEXT | |
| 2.PERFORM TEST MODE (SIGNAL CHECK) |
Turn the ignition switch off.
Perform the sensor check in the Test Mode procedure (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor has been installed properly (Click here).
|
| ||||
| OK | |
| 4.READ VALUE ON TECHSTREAM (YAW RATE AND ACCELERATION SENSOR) |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Select the Data List mode on Techstream (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Deceleration Sensor | Acceleration sensor / min.: -18.52 m/s2, max.: 18.39 m/s2
| Min.: -18.52 m/s2
Max.: 18.39 m/s2 | Reading changes when vehicle is bounced |
| Deceleration Sensor 2 | Acceleration sensor 2 / min.: -18.52 m/s2, max.: 18.39 m/s2
| Min.: -18.52 m/s2
Max.: 18.39 m/s2 | Reading changes when vehicle is bounced |
| Yaw Rate Sensor | Yaw rate sensor / min.: -128 deg/s, max.: 127 deg/s | Vehicle stationary: 0 deg/s Right turn: -128 to 0 deg/s Left turn: 0 to 127 deg/s | - |
| Yaw Rate Sensor 2 | Yaw rate sensor 2 / min.: -128 deg/s, max.: 127 deg/s | Vehicle stationary: 0 deg/s Right turn: -128 to 0 deg/s Left turn: 0 to 127 deg/s | - |
Check that the yaw rate and acceleration sensor output value displayed on Techstream.
|
| ||||
| OK | ||
| ||