Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1379    Downhill Assist Control Switch Malfunction (Test Mode DTC)

for Preparation Click here


DESCRIPTION

DTC C1379 will be deleted when the downhill assist control switch sends a downhill assist control operation signal or when Test Mode ends. DTC C1379 is output only in Test Mode.

DTC Code
DTC Detection Condition
Trouble Area
C1379
Detected only during Test Mode.
Downhill assist control switch

WIRING DIAGRAM


C167504E01


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.READ VALUE ON TECHSTREAM (DOWNHILL ASSIST CONTROL SWITCH)
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Select the Data List mode on Techstream (Click here).

    ABS / VSC / TRAC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Downhill Assist Control SW
    Downhill assist control switch / ON or OFF
    ON: Switch ON
    OFF: Switch OFF
    -

  1. Using Techstream, check the switch condition on Techstream changes according to downhill assist control switch operation.

    OK:
    The Techstream displays ON or OFF according to downhill assist control switch operation.



NG
Go to step 3
OK


2.PERFORM TEST MODE (SIGNAL CHECK)
  1. Turn the ignition switch off.

  1. Perform the sensor check in the Test Mode procedure (Click here).

    OK:
    All Test Mode DTCs are erased.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)  

3.INSPECT DOWNHILL ASSIST CONTROL SWITCH


    C156507E01
  1. Turn the ignition switch off.

  1. Make sure that there is no looseness at the locking part and the connecting part of the connector.

  1. Disconnect the downhill assist control switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (B) - 1 (E)
    Switch is pushed in
    Below 1 Ω
    4 (B) - 1 (E)
    Switch is not pushed in
    10 kΩ or higher

    NOTICE:
    Check the downhill assist control switch signal after replacement (Click here).



NG
REPLACE DOWNHILL ASSIST CONTROL SWITCH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DOWNHILL ASSIST CONTROL SWITCH)


    C168258E01
  1. Make sure that there is no looseness at the locking part and the connecting part of the connector.

  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-26 (HDCS) - g2-4 (B)
    Always
    Below 1 Ω
    A24-26 (HDCS) - Body ground
    Always
    10 kΩ or higher
    g2-1 (E) - Body ground
    Always
    Below 1 Ω

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)