Home › SUSPENSION & AXLE › AXLE › AXLE SYSTEM

AXLE SYSTEM > AWD Warning Remains ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter assembly via CAN communication.
If any of the following is detected, the multi-information display indicates a malfunction in the axle system.
  1. There is a malfunction in the skid control ECU internal circuit.
  2. A low voltage is applied to the power source for the skid control ECU.
  3. There is a malfunction in the CAN communication system.
  4. There is a malfunction in the brake control system.
  5. There is a malfunction in the hybrid control system.
  6. Fail-safe function is operating.
  7. AWD warning illumination demand signal from the HV control ECU is input.

WIRING DIAGRAM


C175273E01


INSPECTION PROCEDURE

1.INSPECT SKID CONTROL ECU (POWER SOURCE CIRCUIT OF SKID CONTROL ECU)
  1. Check the power source circuit of the skid control ECU (Click here).

    HINT:
    According to the power source circuit inspection of the brake control system.

    OK:
    The skid control ECU power source circuit is normal.



NG
REPAIR POWER SOURCE CIRCUIT (ACCORDING TO POWER SOURCE CIRCUIT TROUBLESHOOTING) (Click here)
OK


2.CHECK COMBINATION METER ASSEMBLY
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (READY).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test. (Click here).

  1. Check the operation by referring to the table below.

    ACTIVE TEST: METER 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Meter Display 1
    Multi-information Display
    All the dots in the multi-information display OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Master Warning
    Master Caution Indicator Light
    Master caution indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling

    Result:

    Result
    Proceed to
    The master caution indicator light can be turned on or off using the Techstream.
    A
    The master caution indicator light cannot be turned on or off using the Techstream.
    B
    The master caution indicator light can be turned on or off but not the multi-information display.
    C



B
REPLACE COMBINATION METER ASSEMBLY (Click here)

C
REPAIR CLOCK DISPLAY CIRCUIT (METER/GAUGE SYSTEM) (Click here)
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)