Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1440/98    Steering Angle Sensor Unusual Bank Angle Detected

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in acceleration sensor and detects the vehicle condition.
If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, the DTCs U0123/62 (Lost Communication with Yaw Rate Sensor Module) and U0124/95 (Lost Communication with Lateral Acceleration Sensor Module) are output.

DTC Code
INF Code
DTC Detection Condition
Trouble Area
C1440/98
630
The skid control ECU detects that the vehicle is driving on a bank at an angle of 30 degrees or more.
Yaw rate and acceleration sensor

WIRING DIAGRAM

Refer to DTCs C1234/34, C1243/43, C1244/44, C1245/45 and C1381/97 .

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the skid control ECU, perform initialization and calibration of the linear solenoid valve (Click here).
  2. Before proceeding with the inspection, explain to the customer that the vehicle driving record shows that the vehicle was driven on a bank at an angle of 30°, and confirm that this condition occurred.

HINT:
When DTC U0123/62, U0124/95 and/or U0126/63 is output together with DTC C1440/98, inspect and repair the trouble areas indicated by DTC U0123/62, U0124/95 and/or U0126/63 first (Click here).

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG) again and check that no CAN communication system DTC is output (Click here).

  1. Drive the vehicle at a speed of 30 km/h (19 mph) or more, turn the steering wheel, and decelerate the vehicle (depress the brake pedal) and check that no yaw rate and acceleration sensor DTCs are output (Click here).

    Result:

    Result
    Proceed to
    DTC (C1440/98) is output
    A
    CAN communication system DTC is output
    B
    Yaw rate and acceleration sensor DTC is output
    C
    DTC (C1440/98) is not output
    D

    HINT:
    DTC C1440/98 may have been stored because the vehicle was driven on a bank at an angle of 30°or more.



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)

C
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)

D
CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)
A


2.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION
  1. Turn the power switch off.

  1. Check that the yaw rate and acceleration sensor has been installed properly (Click here).

    OK:
    The sensor should be tightened to the specified torque.
    The sensor should not be installed in a tilted position.



NG
INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY (Click here)
OK

REPLACE SKID CONTROL ECU (Click here)