1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.REMOVE FRONT SEAT ASSEMBLY LH
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL
73900
4.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
58810J
5.REMOVE CONSOLE BOX ASSEMBLY
6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the front door opening trim weatherstrip LH to the extent that allows the removal of the center pillar lower garnish LH.
72138M
7.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH
67918A
8.REMOVE REAR DOOR SCUFF PLATE LH
9.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the rear door opening trim weatherstrip LH to the extent that allows the removal of the center pillar lower garnish LH.
62414A
10.REMOVE LOWER CENTER PILLAR GARNISH LH
73220
11.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
58510D
12.SEPARATE FRONT FLOOR CARPET ASSEMBLY
Disengage the 3 floor carpet hooks to separate the front floor carpet assembly.
58816B
13.REMOVE CONSOLE BOX INSERT
87213
14.REMOVE REAR NO. 2 AIR DUCT
87212
15.REMOVE REAR NO. 1 AIR DUCT
58191B
16.REMOVE FRONT FLOOR FOOTREST
Disengage the 2 clips and remove the front floor footrest.
58563Q
17.DISCONNECT FRONT NO. 3 FLOOR SILENCER
Disconnect the front No. 3 floor silencer to the extent that allows the removal of the parking brake control pedal assembly.
58166
18.REMOVE FRONT FLOOR COVER LH
|
Bolt |
|
Screw |
Remove the 4 bolts, 2 screws and clip (A).
Disengage the 2 clips (B) and remove the front floor cover LH.
58167A
19.REMOVE FRONT CENTER FLOOR COVER
|
Nut |
|
Screw |
Remove the nut and 2 screws.
Disengage the 4 clips and remove the front center floor cover.
58730
20.REMOVE REAR ENGINE SERVICE COVER ASSEMBLY
Remove the 2 bolts and rear engine service cover assembly from the body.
46441
21.LOOSEN NO. 1 WIRE ADJUSTING NUT
Completely release the parking brake pedal.
| *1 | Lock Nut |
| *2 | No. 1 Wire Adjusting Nut |
Remove the lock nut and loosen No. 1 wire adjusting nut to completely release the parking brake cable.
46430
22.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Separate the No. 3 parking brake cable assembly from the parking brake equalizer.
46420
23.SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY
Perform the same procedure as for the No. 3 parking brake cable assembly.
46341
24.REMOVE PARKING BRAKE EQUALIZER
Slide the rubber boot as shown in the illustration.
Remove the parking brake equalizer from the No. 1 parking brake cable assembly as shown in the illustration.
25.REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU
26.REMOVE WIRE HARNESS CLAMP BRACKET
46200
27.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
Remove the 2 bolts and 2 nuts, and separate the No. 1 parking brake cable assembly from the body.
Disengage the clamp.
Pull out the No. 1 parking brake cable assembly toward the cabin.
Disconnect the parking brake switch connector.
Remove the 3 nuts and parking brake control pedal assembly from the body.