Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.11
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0106374 VEHICLE STABILITY CONTROL SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


When troubleshooting a vehicle using the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the skid control ECU (brake actuator assembly).

The skid control ECU (brake actuator assembly) records DTCs when it detects a malfunction in itself or in its circuits.

To check for DTCs, connect the GTS to the DLC3 on the vehicle. The GTS can be used to clear the DTCs, activate various actuators, and check the Freeze Frame Data and Data List.

a.

Check the battery voltage.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge the battery before proceeding to the next step.




DIAGNOSIS


a.

If the skid control ECU (brake actuator assembly) detects a malfunction, the ABS warning, brake warning and/or slip indicator lights will come on in order to warn the driver.

HINT:

If the downhill assist control switch is on, the downhill assist control indicator light will blink (for AWD).



b.

DTCs are simultaneously stored in memory.

The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning and slip indicator lights, or by connecting the GTS.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR


c.

This system has a Test Mode (signal check) function.

The DTCs can be read by connecting SST between terminals TS and CG of the DLC3 and observing the blinking pattern of the ABS warning and slip indicator lights, or by connecting the GTS.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE



WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK


a.

When the ignition switch is turned to ON, check that the ABS warning, brake warning, VSC OFF indicator, slip indicator and downhill assist control indicator (for AWD) lights all come on for approximately 3 seconds.

HINT:
·

If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS warning, brake warning, VSC OFF indicator, slip indicator and downhill assist control indicator (for AWD) light circuits.

·

If any of the indicators remains on or does not come on, proceed to troubleshooting for the light circuits listed below.

·

When the brake fluid level is low, the brake warning light comes on.



Trouble Area See procedure
ABS warning light circuit (Remains on) (Click here)
ABS warning light circuit (Does not come on) (Click here)
Brake warning light circuit (Remains on) (Click here)
Brake warning light circuit (Does not come on) (Click here)
VSC OFF indicator light circuit (Remains on) (Click here)
VSC OFF indicator light circuit (Does not come on) (Click here)
Slip indicator light circuit (Remains on) (Click here)
Slip indicator light circuit (Does not come on) (Click here)
Downhill assist control indicator light circuit (Remains on)* (Click here)
Downhill assist control indicator light circuit (Does not come on)* (Click here)

*: for AWD