The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transfer case oil seal removal/installation are shown below.
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
| *a | An Object Exceeding Weight Limit of Transmission Jack |
The automatic transaxle assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
36100
1.REMOVE TRANSFER ASSEMBLY
36100A
2.REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT
36100
3.SECURE TRANSFER ASSEMBLY
4.INSPECT TOTAL PRELOAD
5.REMOVE OUTPUT SHAFT COMPANION FLANGE NUT
33309
6.REMOVE TRANSFER OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
36111X
7.REMOVE TRANSFER CASE OIL SEAL
| *1 | Transfer Case Oil Seal |
Using SST, remove the transfer case oil seal from the transfer assembly.
Do not scratch the press-fitting surface of the transfer case oil seal.
Remove the spacer from the transfer assembly.
| *1 | Rear Drive Pinion Bearing (Inner Race) |
Using SST, remove the rear drive pinion bearing (inner race) from the transfer assembly.
Remove the transfer pinion bearing spacer from the transfer assembly.
Using SST, remove the rear drive pinion bearing (outer race) from the transfer assembly.
| *1 | Rear Drive Pinion Bearing (Outer Race) | - | - |
| *a | Turn | *b | Hold |
36111X
8.INSTALL TRANSFER CASE OIL SEAL
| *1 | Rear Drive Pinion Bearing (Outer Race) |
Using SST and a press, install the rear drive pinion bearing (outer race) to the transfer assembly.
Install a new transfer pinion bearing spacer to the transfer assembly.
Temporarily install the transfer output shaft companion flange sub-assembly and rear drive pinion bearing (inner race) to the transfer assembly.
| *a | Turn |
| *b | Hold |
Using SST, install the rear drive pinion bearing (inner race).
| *a | Turn |
| *b | Hold |
Using SST, remove the transfer output shaft companion flange sub-assembly from the transfer assembly.
install the spacer to the transfer assembly.
Coat the lip of a new transfer case oil seal with MP grease.
| *1 | Transfer Case Oil Seal |
| *a | Depth |
Using SST and a hammer, tap in the transfer case oil seal to the transfer assembly as shown in the illustration.
3.9 to 4.9 mm (0.154 to 0.193 in.)
Do not damage the transfer case oil seal press-fit surface.
Set surface A of SST to the transfer case oil seal.
33309
9.INSTALL TRANSFER OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
10.INSPECT TOTAL PRELOAD
11.INSTALL OUTPUT SHAFT COMPANION FLANGE NUT
36100
12.REMOVE TRANSFER ASSEMBLY
36100A
13.INSTALL TRANSFER AND TRANSAXLE SETTING STUD BOLT
36100
14.INSTALL TRANSFER ASSEMBLY