FOR HV MODEL
The combination meter assembly receives vehicle speed signals from the No. 2 skid control ECU (brake actuator assembly) via CAN communication. The speed sensor detects the wheel speed and sends the appropriate signals to the No. 2 skid control ECU (brake actuator assembly). The No. 2 skid control ECU (brake actuator assembly) supplies power to the vehicle speed sensor. The No. 2 skid control ECU (brake actuator assembly) detects vehicle speed signals based on pulses of the voltage.
FOR GASOLINE MODEL
The combination meter assembly receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication. The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU (brake actuator assembly). The skid control ECU (brake actuator assembly) supplies power to the vehicle speed sensor. The skid control ECU (brake actuator assembly) detects vehicle speed signals based on pulses of the voltage.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Factors that affect the indicated vehicle speed include the tire size, tire pressure, and tire wear. The speed indicated on the speedometer has an allowable margin of error. For details about testing and the margin of error, see the reference chart.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>ON-VEHICLE INSPECTION
Before starting the following inspection, check that the tire size and tire pressures are as specified.
Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION
Check if CAN communication DTCs are output.
for HV Model: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>DIAGNOSIS SYSTEM
for Gasoline Model: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
for HV Model: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>HOW TO PROCEED WITH TROUBLESHOOTING
for Gasoline Model: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>HOW TO PROCEED WITH TROUBLESHOOTING
Check if electronically controlled brake system DTCs are output.
for HV Model
for Gasoline Model
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
for HV Model: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>DIAGNOSTIC TROUBLE CODE CHART
for Gasoline Model: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DIAGNOSTIC TROUBLE CODE CHART
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Speedometer Operation (0km/h,0MPH) | Speedometer
(0 km/h, 0 mph) |
ON | When this Active Test is performed, an operation signal is sent directly to the combination meter assembly to operate the speedometer. |
| Speedometer Operation (40km/h,40MPH) | Speedometer
(40 km/h, 40 mph) |
ON | ·
When this Active Test is performed, an operation signal is sent directly to the combination meter assembly to operate the speedometer. ·
The value displayed on the speedometer may deviate.* |
| Speedometer Operation (80km/h,80MPH) | Speedometer
(80 km/h, 80 mph) |
ON | ·
When this Active Test is performed, an operation signal is sent directly to the combination meter assembly to operate the speedometer. ·
The value displayed on the speedometer may deviate.* |
| Speedometer Operation (120km/h,120MPH) | Speedometer
(120 km/h, 120 mph) |
ON | ·
When this Active Test is performed, an operation signal is sent directly to the combination meter assembly to operate the speedometer. ·
The value displayed on the speedometer may deviate.* |
| Speedometer Operation (160km/h,160MPH) | Speedometer
(160 km/h, 160 mph) |
ON | ·
When this Active Test is performed, an operation signal is sent directly to the combination meter assembly to operate the speedometer. ·
The value displayed on the speedometer may deviate.* |
| Speedometer Operation (200km/h,200MPH) | Speedometer
(200 km/h, 200 mph) |
ON | ·
When this Active Test is performed, an operation signal is sent directly to the combination meter assembly to operate the speedometer. ·
The value displayed on the speedometer may deviate.* |
| Speedometer Operation (240km/h,240MPH) | Speedometer
(240 km/h, 240 mph) |
ON | When this Active Test is performed, an operation signal is sent directly to the combination meter assembly to operate the speedometer. |
*: For the tolerance of each Speed Signal Input Active Test, refer to On-vehicle Inspection.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>ON-VEHICLE INSPECTION
| Tester Display |
|---|
| Speedometer Operation (0km/h,0MPH) |
| Tester Display |
|---|
| Speedometer Operation (40km/h,40MPH) |
| Tester Display |
|---|
| Speedometer Operation (80km/h,80MPH) |
| Tester Display |
|---|
| Speedometer Operation (120km/h,120MPH) |
| Tester Display |
|---|
| Speedometer Operation (160km/h,160MPH) |
| Tester Display |
|---|
| Speedometer Operation (200km/h,200MPH) |
| Tester Display |
|---|
| Speedometer Operation (240km/h,240MPH) |
Speedometer indication is normal.
When the value of the Active Test is more than or equal to the speedometer upper limit, the indicated speed stops at the upper limit.
| Result | Proceed to |
|---|---|
| OK
(for HV Model) |
A |
| OK
(for Gasoline Model) |
B |
| NG | C |
A
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model RHD)>REMOVAL
B
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model RHD)>REMOVAL
C