The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front frame assembly removal/installation are shown below.
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
for A25A-FXS, A25B-FXS: Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
23825
2.REMOVE FUEL DELIVERY GUARD (for A25A-FXS, A25B-FXS)
3.INSTALL ENGINE HANGERS
for A25A-FXS, A25B-FXS: Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
45319
4.REMOVE STEERING GEAR HEAT INSULATOR (for LHD)
5.DISCONNECT WIRE HARNESS
for LHD: Click hereSteering>STEERING GEAR / LINKAGE>STEERING GEAR>REMOVAL
for RHD: Click hereSteering>STEERING GEAR / LINKAGE>STEERING GEAR>REMOVAL
6.REMOVE FRONT FRAME ASSEMBLY
Remove the 3 nuts and separate the front engine mounting insulator from the front frame assembly.
Remove the 4 nuts and separate the rear engine mounting insulator from the front frame assembly.
7.REMOVE FRONT STABILIZER BAR SUB-ASSEMBLY WITH LINK
44250
8.REMOVE RACK AND PINION POWER STEERING GEAR ASSEMBLY
48069
9.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly LH from the front frame assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.
48068
10.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
17572B
11.REMOVE NO. 2 EXHAUST PIPE SUPPORT BRACKET (for A25A-FXS, A25B-FXS)
Remove the 2 bolts and No. 2 exhaust pipe support bracket from the front frame assembly.
32913
12.REMOVE OIL COOLER BRACKET
Remove the bolt and oil cooler bracket from the front frame assembly.
13.REMOVE HOLE PLUG
Remove the 7 hole plugs from the front frame assembly.
There are 2 different shapes of hole plug.