Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › from 2020.11
RM37A0E _56 Audio / Visual / Telematics _086880 PARK ASSIST / MONITORING _0420014 PARKING ASSIST MONITOR SYSTEM J

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  Image from Camera for Parking Assist Monitor is Abnormal  


DESCRIPTION

The display signal from the rear television camera assembly is transmitted to the radio and display receiver assembly or multi-display assembly.

WIRING DIAGRAM

for 8 Inch Display
E404564E05
5.75,0.646 6.208,0.844 0.458,0.198 10 false CA+ 5.771,1.104 6.229,1.302 0.458,0.198 10 false V+ 5.76,1.573 6.219,1.771 0.458,0.198 10 false V- 5.729,2.031 6.188,2.229 0.458,0.198 10 false CGND 5.438,0.531 5.896,0.729 0.458,0.198 10 false 30 5.438,1.01 5.896,1.208 0.458,0.198 10 false 28 5.438,1.479 5.896,1.677 0.458,0.198 10 false 29 5.438,1.927 5.896,2.125 0.458,0.198 10 false 27 3.406,2.417 4.073,2.615 0.667,0.198 10 false * 1.563,0.563 2.021,0.76 0.458,0.198 10 false 6 1.563,1.01 2.021,1.208 0.458,0.198 10 false 3 1.573,1.479 2.031,1.677 0.458,0.198 10 false 2 1.563,1.938 2.021,2.135 0.458,0.198 10 false 5 1.125,0.677 1.583,0.875 0.458,0.198 10 false CB+ 1.135,1.104 1.594,1.302 0.458,0.198 10 false CV+ 1.177,1.573 1.635,1.771 0.458,0.198 10 false CV- 1.031,2.031 1.49,2.229 0.458,0.198 10 false CGND 5.219,2.729 5.677,2.927 0.458,0.198 10 false H2 5.229,2.927 6.917,3.292 1.688,0.365 10 false Radio and Display Receiver Assembly 0.271,2.688 0.729,2.885 0.458,0.198 10 false W15 0.281,2.865 1.75,3.302 1.469,0.438 10 false Rear Television Camera Assembly 5.74,2.406 6.198,2.604 0.458,0.198 10 false CSLD 5.438,2.292 5.896,2.49 0.458,0.198 10 false 26 2.667,3.375 3.438,3.563 0.771,0.188 10 false *: Shielded

for 12.3 Inch Display
E460840E01
5.75,0.646 6.208,0.844 0.458,0.198 10 false CA+ 5.771,1.104 6.229,1.302 0.458,0.198 10 false V+ 5.76,1.573 6.219,1.771 0.458,0.198 10 false V- 5.729,2.031 6.188,2.229 0.458,0.198 10 false CGND 5.438,0.531 5.896,0.729 0.458,0.198 10 false 10 5.438,1.01 5.896,1.208 0.458,0.198 10 false 8 5.438,1.479 5.896,1.677 0.458,0.198 10 false 9 5.438,1.927 5.896,2.125 0.458,0.198 10 false 21 3.406,2.417 4.073,2.615 0.667,0.198 10 false * 1.563,0.563 2.021,0.76 0.458,0.198 10 false 6 1.563,1.01 2.021,1.208 0.458,0.198 10 false 3 1.573,1.479 2.031,1.677 0.458,0.198 10 false 2 1.563,1.938 2.021,2.135 0.458,0.198 10 false 5 1.125,0.677 1.583,0.875 0.458,0.198 10 false CB+ 1.135,1.104 1.594,1.302 0.458,0.198 10 false CV+ 1.177,1.573 1.635,1.771 0.458,0.198 10 false CV- 1.031,2.031 1.49,2.229 0.458,0.198 10 false CGND 5.333,2.74 5.792,2.938 0.458,0.198 10 false H7 5.375,2.938 7.063,3.302 1.688,0.365 10 false Multi-display Assembly 0.271,2.688 0.729,2.885 0.458,0.198 10 false W15 0.281,2.865 1.75,3.302 1.469,0.438 10 false Rear Television Camera Assembly 5.74,2.406 6.198,2.604 0.458,0.198 10 false CSLD 5.438,2.292 5.896,2.49 0.458,0.198 10 false 20 2.667,3.375 3.438,3.563 0.771,0.188 10 false *: Shielded

CAUTION / NOTICE / HINT

NOTICE:
·

When the "!" mark is displayed on the radio and display receiver assembly or multi-display assembly after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



HINT:

Images may be unclear even in normal conditions if:

·

Electrical devices are used in the cabin (noise may occur in the image).

·

Accessories that generate radio waves have been installed (noise may occur in the image).

·

The display of radio and display receiver assembly or multi-display assembly is cold (the image immediately after turning the ignition switch to ON may be blurred or darker than normal).

·

The camera lens is dirty with snow, mud, etc.

·

A strong beam of light, such as a sunbeam or headlight, hits the camera.

·

It is too dark around the camera (at night, etc.).

·

The ambient temperature around the camera is either too high or too low.

·

The vehicle is tilted at a steep angle.

·

The rear television camera assembly lens is scratched.

·

The rear television camera assembly lens has drops of water on it or the humidity is high.

·

When the camera is used under fluorescent lights, sodium lights, mercury lights, etc., the lights and the illuminated area may appear to flicker.



PROCEDURE

1.CHECK MODEL
a.

Choose the model to be inspected.

Result:
Result Proceed to
for 8 Inch Display A
for 12.3 Inch Display B




A

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

B

4.CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

OK

3.REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.REPLACE REAR TELEVISION CAMERA ASSEMBLY
a.

Replace the rear television camera assembly with a new or known good one.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA (for Rear)>REMOVAL


b.

Check if the same malfunction reoccurs when the rear view monitor screen is displayed.

OK:

Malfunction does not reoccur (returns to normal).



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

4.CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

OK

5.REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.REPLACE REAR TELEVISION CAMERA ASSEMBLY
a.

Replace the rear television camera assembly with a new or known good one.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA (for Rear)>REMOVAL


b.

Check if the same malfunction reoccurs when the rear view monitor screen is displayed.

OK:

Malfunction does not reoccur (returns to normal).



Result:
Proceed to
OK
NG



OK

END

NG