PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
- HINT:
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- NOTICE:
- When replacing the skid control ECU, sensor, etc., turn the ignition switch OFF.
| Symptom |
Suspected Area |
See page |
| ABS does not operate |
IG power source circuit (ground circuit) |
Click here
|
| Front speed sensor circuit |
Click here
|
|
| Rear speed sensor circuit |
Click here
|
|
| Brake actuator (hydraulic circuit) |
Click here
|
|
| When above areas are all normal but problem still occurs, replace skid control ECU |
- |
|
| ABS does not operate properly |
Front speed sensor circuit |
Click here
|
| Rear speed sensor circuit |
Click here
|
|
| Stop light switch circuit |
Click here
|
|
| Brake actuator (hydraulic circuit) |
Click here
|
|
| When above areas are all normal but problem still occurs, replace skid control ECU |
- |
|
| ABS warning light malfunction |
Refer to ABS Warning Light Remains ON |
Click here
|
| Refer to ABS Warning Light does not Come ON |
Click here
|
|
| Skid control ECU |
- |
|
| DTC check cannot be performed |
Refer to ABS Warning Light Remains ON |
Click here
|
| Refer to ABS Warning Light does not Come ON |
Click here
|
|
| TC and CG terminal circuit |
Click here
|
|
| When above areas are normal but problem still occurs, replace skid control ECU |
- |
|
| Speed sensor signal check cannot be performed |
TS and CG terminal circuit |
Click here
|
| Skid control ECU |
- |