2014 Hilux · Service Manual BRAKE

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.

NOTICE:
When replacing the skid control ECU, sensor, etc., turn the ignition switch OFF.

Brake control system 
Symptom
Suspected Area
See page
ABS does not operate
IG power source circuit (ground circuit)
Click here
Front speed sensor circuit
Click here
Rear speed sensor circuit
Click here
Brake actuator (hydraulic circuit)
Click here
When above areas are all normal but problem still occurs, replace skid control ECU
-
ABS does not operate properly
Front speed sensor circuit
Click here
Rear speed sensor circuit
Click here
Stop light switch circuit
Click here
Brake actuator (hydraulic circuit)
Click here
When above areas are all normal but problem still occurs, replace skid control ECU
-
ABS warning light malfunction
Refer to ABS Warning Light Remains ON
Click here
Refer to ABS Warning Light does not Come ON
Click here
Skid control ECU
-
DTC check cannot be performed
Refer to ABS Warning Light Remains ON
Click here
Refer to ABS Warning Light does not Come ON
Click here
TC and CG terminal circuit
Click here
When above areas are normal but problem still occurs, replace skid control ECU
-
Speed sensor signal check cannot be performed
TS and CG terminal circuit
Click here
Skid control ECU
-
← PROBLEM SYMPTOMS TABLE (Aug 2012 – Jul 2013)TERMINALS OF ECU (Jun 2011 – Jul 2013) →