Inspect the torque converter clutch assembly (Click here).
2.
INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY
Install the torque converter clutch to the automatic transmission.
Using a vernier caliper and straightedge, measure dimension A between the surface of the engine that contacts the transmission*1, and the surface of the drive plate that contacts the converter*2. (#)
Using a vernier caliper and straightedge, measure dimension B shown in the illustration. Check that B is greater than A measured in step #.
21.
INSTALL TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY
While pushing the select return spring to the left with the end of the transfer high and low shift lever, insert the end of the shift lever into the shift fork.
While holding down the shift lever cap, install the snap ring to install the transfer high and low shift lever.
Return the transfer front drive shift boot to its original position.
22.
INSTALL SHIFT LEVER BOOT ASSEMBLY
Install the shift lever boot with the 4 screws.
23.
INSTALL CONSOLE BOX ASSEMBLY
Install the console box with the 4 screws and 2 bolts.
Install the 2 clips.
Text in Illustration
*1
Screw
*2
Bolt
*3
Clip
24.
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
Attach the 12 claws to install the upper console panel.
Text in Illustration
*A
for 2WD
*B
for 4WD
25.
INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY
Attach the 4 claws to install the parking brake hole cover.
26.
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Install the shift lever knob and twist it in the direction indicated by the arrow.
27.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.
When moving the shift lever from P to R with the ignition switch ON and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.
Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D, and moves in reverse after shifting to R. If the results are not as specified, inspect the park/ neutral position switch and check the shift lever.