When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.REMOVE NO. 1 TIMING BELT COVER
2.REMOVE TIMING BELT
3.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
4.REMOVE CRANKSHAFT PULLEY
Using SST, hold the crankshaft pulley and loosen the pulley bolt.
Using SST, remove the pulley bolt and crankshaft pulley.
Apply oil or grease to the threads and tip of SST (center bolt) before using it.
5.REMOVE NO. 2 INTERCOOLER SUPPORT BRACKET
Remove the 2 bolts and No. 2 intercooler support bracket.
6.REMOVE NO. 1 INTERCOOLER SUPPORT BRACKET
Remove the 2 bolts and No. 1 intercooler support bracket.
7.REMOVE NO. 2 IDLE PULLEY ASSEMBLY
Remove the bolt, pulley plate, No. 2 idle pulley and spacer.
8.REMOVE GENERATOR ASSEMBLY
9.REMOVE GENERATOR BRACKET
Remove the bolt and generator bracket.
10.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Remove the 4 bolts and V-ribbed belt tensioner.
11.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System)
Remove the 4 bolts and No. 1 compressor mounting bracket.
12.REMOVE TURBOCHARGER SUB-ASSEMBLY
13.REMOVE EXHAUST MANIFOLD
Remove the 8 nuts, 8 plate washers, 8 collars and exhaust manifold.
Remove the gasket.
14.REMOVE WATER INLET
15.REMOVE THERMOSTAT
16.REMOVE WATER OUTLET
Remove the 2 bolts, water outlet and gasket.
17.REMOVE DIESEL THROTTLE BODY ASSEMBLY
18.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY
19.REMOVE INTAKE MANIFOLD
20.REMOVE GLOW PLUG ASSEMBLY
21.REMOVE FUEL HOSE PROTECTOR (for DPF)
Remove the bolt, nut and fuel hose protector.
22.REMOVE NO. 1 FUEL PIPE (for DPF)
Remove the No. 1 fuel pipe from the fuel hose bracket.
23.REMOVE FUEL HOSE BRACKET (for DPF)
Remove the bolt and fuel hose bracket.
24.REMOVE WIRING HARNESS CLAMP BRACKET (for i-ART)
25.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY
26.REMOVE OIL FILTER SUB-ASSEMBLY
27.REMOVE COMMON RAIL ASSEMBLY
28.REMOVE FUEL SUPPLY PUMP ASSEMBLY
29.REMOVE OIL COOLER COVER SUB-ASSEMBLY
30.REMOVE VACUUM PUMP ASSEMBLY
Remove the 2 nuts, vacuum pump and 2 O-rings.
31.REMOVE VANE PUMP ASSEMBLY
Remove the 2 nuts, vane pump and O-ring.
32.REMOVE CRANKSHAFT POSITION SENSOR
33.REMOVE CAMSHAFT POSITION SENSOR
34.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
35.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET RH
| *A | RH Side |
| *B | LH Side |
Remove the 4 bolts and front No. 1 engine mounting bracket.
36.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH
Remove the 4 bolts and front No. 1 engine mounting bracket.