1.INSTALL FUEL FILLER OPENING LID LOCK RETAINER
Install the fuel filler opening lid lock retainer and turn it counterclockwise as shown in the illustration.
2.INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Install the fuel lid lock control cable and turn the fuel filler opening lid lock retainer clockwise as shown in the illustration.
Attach the cable to the clamps shown in the illustration.
Install the grommet to the vehicle body.
Install the fuel lid lock open lever.
| *1 | Fuel Lid Lock Open Lever | *2 | Grommet |
3.INSTALL REAR WHEEL HOUSE LINER LH
Install the rear wheel house liner.
4.INSTALL REAR NO. 1 WHEEL OPENING EXTENSION SUB-ASSEMBLY LH (w/ Over Fender)
5.INSTALL FRONT FLOOR CARPET ASSEMBLY
Install the floor carpet.
6.INSTALL LOWER QUARTER TRIM PANEL LH
Attach the 3 clips and claw to install the lower quarter trim panel.
Install the front door opening trim.
7.INSTALL LOWER CENTER PILLAR GARNISH LH
Attach the 2 clips, 2 claws and 2 guides to install the lower center pillar garnish.
Install the front door opening trim.
Connect the front seat outer belt floor anchor with the bolt.
8.INSTALL REAR DOOR SCUFF PLATE LH
9.INSTALL COWL SIDE TRIM BOARD LH
Attach the 2 clips to install the cowl side trim board.
Install the clip.
10.INSTALL FRONT DOOR SCUFF PLATE LH
11.INSTALL UPPER BACK PANEL GARNISH
12.INSTALL CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
13.INSTALL REAR SEAT ASSEMBLY
14.INSTALL FRONT SEAT ASSEMBLY LH
for Manual Seat:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Separate Seat Type)>INSTALLATION)
for Power Seat:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION)
15.INSTALL FRONT SEAT ASSEMBLY RH
for Manual Seat:
Use the same procedure described for the LH side.
for Bench Seat Type:
(See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>INSTALLATION)