Perform these procedures after the engine has cooled down.
1.INSPECT TIMING BELT
3.INSPECT TIMING BELT PULLEY
4.CLEAN TIMING BELT COVER (for 1KD-FTV)
This is for vehicles often used in excessively dusty conditions. Inspect for cracks on the timing belt or abnormal wear on the timing pulley. Then, remove sand and dust in the timing belt cover.
Remove the timing belt cover.
Check that the timing belt cover is not dirty.
If cleaning a timing belt cover, blow compressed air to clean it.
Reinstall the timing belt cover.
8.INSPECT COOLING AND HEATER SYSTEM
Check that the radiator, condenser and/or intercooler is not blocked with leaves, dirt or insects, and clean them if necessary. Also check the hose connection for the installation condition, corrosion, etc.
11.INSPECT ENGINE OIL COOLER HOSES AND CONNECTIONS (for 1GR-FE)
Check the oil cooler hoses for cracks, leakage, loose connections and deformation.
12.INSPECT EXHAUST PIPES AND MOUNTINGS
Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
13.REPLACE DPR HOSE (w/ DPF)
17.REPLACE FUEL FILTER
20.INSPECT FUEL LINES, FUEL LINE CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BAND
Visually check the fuel lines and hoses for cracks, leakage, loose connections and deformation. Also, visually check the tank band for looseness.