Home › Vehicle Interior › POWER OUTLETS (INT) › POWER POINT SOCKET(for Single Socket Type) › 2015.06–2016.03
RM3250E _58 Vehicle Interior _038074 POWER OUTLETS (INT) _0186362 POWER POINT SOCKET(for Single Socket Type) A

POWER OUTLETS (INT)  POWER POINT SOCKET(for Single Socket Type)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION (w/ Airbag System)

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45100 3.REMOVE STEERING WHEEL ASSEMBLY

Hide 55410C 4.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 58810J 5.REMOVE CONSOLE BOX ASSEMBLY (w/ Console Box Lid)

Hide 58810J 6.REMOVE CONSOLE BOX ASSEMBLY (w/o Console Box Lid)

Hide 55900 10.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

Hide 45287 11.REMOVE STEERING COLUMN LOWER COVER

Hide 55606 12.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)

Hide 73900 13.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY (w/ Knee Airbag)

Hide 55045 14.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (w/o Knee Airbag)

Hide 55407C 15.REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY

Hide 85530 16.REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY

a.
E323449C01
0,0 0,0 false
V100155

Protective Tape
V113147

Remove in this Direction


Using a thin-bladed screwdriver, detach the claw, and remove the No. 1 power outlet socket assembly as shown in the illustration.

HINT:

Tape the thin-bladed screwdriver tip before use.



Hide 85535B 17.REMOVE NO. 1 POWER OUTLET SOCKET COVER

a.
E323446C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and remove the No. 1 power outlet socket cover as shown in the illustration.