Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
1. PRECAUTION (w/ Airbag System)
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45100
3.REMOVE STEERING WHEEL ASSEMBLY
55410C
4.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
58810J
5.REMOVE CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
58810J
6.REMOVE CONSOLE BOX ASSEMBLY (w/o Console Box Lid)
55905J
7.REMOVE CONTROL KNOB SUB-ASSEMBLY
for Manual Cooler System:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Manual Cooler System)>REMOVAL
for Manual Air Conditioning System:
55918A
8.REMOVE AIR INLET DAMPER CONTROL LEVER
for Manual Cooler System:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Manual Cooler System)>REMOVAL
for Manual Air Conditioning System:
84013A
9.REMOVE INTEGRATION PANEL SUB-ASSEMBLY
for Manual Cooler System:
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Manual Cooler System)>REMOVAL
for Manual Air Conditioning System:
55900
10.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
45287
11.REMOVE STEERING COLUMN LOWER COVER
55606
12.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)
73900
13.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY (w/ Knee Airbag)
55045
14.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (w/o Knee Airbag)
55407C
15.REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY
85530
16.REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY
Use the same procedure for both power outlet socket assemblies.
|
Protective Tape |
|
Remove in this Direction |
Using a thin-bladed screwdriver, detach the claw, and remove the No. 1 power outlet socket assembly as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
85535B
17.REMOVE NO. 1 POWER OUTLET SOCKET COVER
Use the same procedure for both power outlet socket covers.
|
Remove in this Direction |
Detach the claw and remove the No. 1 power outlet socket cover as shown in the illustration.