1.REMOVE IGNITION COIL ASSEMBLY
2.REMOVE PCV PIPE
Disconnect the PCV hose from the PCV valve sub-assembly and intake manifold.
Remove the bolt and PCV pipe.
3.REMOVE GENERATOR ASSEMBLY
4.REMOVE ENGINE WIRE
Disconnect the oil pressure switch connector.
Disconnect the noise filter connector.
Disconnect the camshaft position sensor connector.
Disconnect the 4 injector connectors.
Disconnect the crankshaft position sensor connector.
Disconnect the camshaft timing oil control valve connector.
Disconnect the purge VSV connector.
Disconnect the throttle body connector.
Disconnect the engine coolant temperature sensor connector.
Disconnect the knock sensor connector.
Disconnect the wire harness from the clamps.
Remove the 2 bolts and wire harness from the engine.
5.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
6.REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR
7.REMOVE PURGE VSV
8.REMOVE INTAKE MANIFOLD
Disconnect the crankshaft position sensor from the clamp.
Remove the 5 bolts, 2 nuts, intake manifold and gasket.
9.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
10.REMOVE EXHAUST MANIFOLD
11.REMOVE IDLE PULLEY ASSEMBLY
Loosen the bolt and then remove the idle pulley assembly.
The bolt in the illustration cannot be removed from the idle pulley assembly.
12.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
Remove the 5 bolts and No. 1 compressor mounting bracket.
13.REMOVE NO. 1 IDLER PULLEY SUB-ASSEMBLY
14.REMOVE HEATER WATER INLET HOSE
15.REMOVE HEATER WATER OUTLET HOSE
16.REMOVE NO. 1 WATER BY-PASS PIPE
Remove the 2 nuts, water by-pass pipe and gasket.
17.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH
Remove the 4 bolts and engine mounting bracket.
18.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET RH
Remove the 4 bolts and engine mounting bracket.