Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL REAR COIL SPRING
Install the coil spring and insulator to the lower control arm and frame. Fit the lower end of the coil spring into the recess of the spring lower seat.
2.TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
3.INSTALL REAR WHEEL
4.STABILIZE SUSPENSION
5.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
6.CONNECT REAR BRAKE TUBE FLEXIBLE HOSE
Install the hose to the 3 way joint.
Install the clip to the flexible hose.
Connect the flexible hose to the brake line.
7.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
8.INSTALL TAILPIPE ASSEMBLY
9.CONNECT REAR SPEED SENSOR LH
10.BLEED BRAKE LINE
11.CHECK ABS SPEED SENSOR SIGNAL