Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM
RM1880E _58 Vehicle Interior _013237 DOOR LOCK _0068604 POWER DOOR LOCK CONTROL SYSTEM T

DOOR LOCK  POWER DOOR LOCK CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:

When replacing the theft warning ECU assembly, refer to the registration procedures (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Theft Deterrent System)>REGISTRATION).


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Power Door Lock Control System
Symptom Suspected Area Link
No door lock/unlock functions operate via power window regulator master switch assembly or driver side door key cylinder Proceed to "All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch, Driver Side Door Key Cylinder" Click here
Only driver door lock/unlock functions do not operate Front door lock assembly LH (for LHD) Click here
Front door lock assembly RH (for RHD) Click here
Harness or connector -
Driver side junction block assembly -
Only front passenger door lock/unlock functions do not operate Front door lock assembly RH (for LHD) Click here
Front door lock assembly LH (for RHD) Click here
Harness or connector -
Driver side junction block assembly -
Only rear door LH lock/unlock functions do not operate Rear door lock assembly LH Click here
Harness or connector -
Driver side junction block assembly -
Only rear door RH lock/unlock functions do not operate Rear door lock assembly RH Click here
Harness or connector -
Driver side junction block assembly -
Only back door lock/unlock functions do not operate Back door lock assembly Click here
Harness or connector -
Driver side junction block assembly -
2 step unlock function does not operate (w/ Theft Deterrent System) Check customize parameters Click here
Harness or connector -
Theft warning ECU assembly Click here