Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH
RM1880E _58 Vehicle Interior _013237 DOOR LOCK _0068610 UNLOCK WARNING SWITCH A

DOOR LOCK  UNLOCK WARNING SWITCH  INSTALLATION  


PROCEDURE

Hide 1.INSTALL UNLOCK WARNING SWITCH ASSEMBLY

a.
B281349
1.323,1.323 1.323,1.802 true 1.24,1.823 1.542,2.063 0.302,0.24 10 false *1
*1 Pin


While pushing the pin, slide the warning switch to install it.


b.
B281530

Connect the unlock warning switch connector.


Hide 2.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY

Hide 3.INSTALL CYLINDER LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 4.INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)

Hide 7.INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).