2013-2015 Land Cruiser Prado · Service Manual Suspension

DIAGNOSTIC TROUBLE CODE CHART

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

NOTICE:
Turn the ignition switch off before removing parts.

HINT:
  1. If no abnormality is found when inspecting parts, inspect the skid control ECU and ground points for poor contact.
  2. If a trouble code is output during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the "See page" for the respective "DTC Code" in the DTC chart.
  3. When 2 or more DTCs are output, perform circuit inspections one by one until the problem is identified.
  4. Inspect the fuse and relay before investigating the trouble areas as shown in the table below.

Kinetic Dynamic Suspension System 
DTC Code
Detection Item
See page
C1812/12
Pressure Sensor Malfunction / Upside
Click here
C1831/31
Accumulator Solenoid Malfunction / Upside
Click here
C1832/32
Accumulator Solenoid Malfunction / Downside
Click here
C1851/51
Low Pressure Malfunction in Upside of KDSS System
Click here
C1853/53
High Pressure Malfunction in Upside of KDSS System
Click here
C1879/79
Zero Point Calibration of Acceleration Sensor Undone
Click here
C1881/81
KDSS ECU Malfunction
Click here
C1882/82
Power Supply Voltage Malfunction
Click here
C1883/83
Speed Sensor Circuit Malfunction
Click here
C1884/84
Steering Angle Sensor Circuit Malfunction
Click here
C1887/87
Acceleration Sensor Circuit Malfunction
Click here
U0100/71
Lost Communication with ECM/PCM "A"
Click here
U0122/71
Lost Communication with Vehicle Dynamics Control Module
Click here
U0124/71
Lost Communication with Lateral Acceleration Sensor Module
Click here
U0126/71
Lost Communication with Steering Angle Sensor Module
Click here
← DATA LIST / ACTIVE TEST (from Aug 2013)DIAGNOSTIC TROUBLE CODE CHART (from Aug 2014) →