Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
The fold seat control ECU receives signals from the park/neutral position switch and controls the seat folding and return operations. If the shift lever is in any position other than P when the ignition switch is ON, the seat cannot be operated.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK FOLD SEAT CONTROL ECU (PARK/NEUTRAL POSITION SWITCH SIGNAL)
Remove the fold seat control ECU with its connectors still connected (Click here).
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for LH Side
Tester Connection
Condition
Specified Condition
d1-6 (P) - Body ground
Ignition switch ACC or ON Shift lever in P
11 to 14 V
Ignition switch ACC or ON Shift lever not in P
Below 1 V
for RH Side
Tester Connection
Condition
Specified Condition
c1-6 (P) - Body ground
Ignition switch ACC or ON Shift lever in P
11 to 14 V
Ignition switch ACC or ON Shift lever not in P
Below 1 V
Text in Illustration
*A
for LH Side
*B
for RH Side
*a
Component with harness connected (Fold Seat Control ECU)