2013-2015 Land Cruiser Prado · Service Manual General

GENERAL MAINTENANCE

Removal / installation · Vehicles built from Aug 2013


1. INSPECT POWER STEERING FLUID LEVEL
Type
See Procedures
for 1GR-FE
Click here
for 1KD-FTV
Click here
for 5L-E
Click here
for 2TR-FE
Click here

2. INSPECT STEERING LINKAGE AND GEAR HOUSING
  1. Check the steering wheel free play (Click here).

  1. Check the steering linkage for looseness or damage.

    1. Check that the tie rod ends do not have excessive play.

    2. Check that the dust seals and boots are not damaged.

    3. Check that the boot clamps are not loose.

    4. Check that the steering gear housing is not damaged.

    5. Check that the connectors are properly connected to the steering gear housing.


3. INSPECT BALL JOINT AND DUST COVER
  1. Inspect the ball joints for excessive looseness.

    1. Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.

    2. Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.

    3. Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.

    4. Using a lever, pry up the end of the lower arm. Check the amount of play.

      Maximum ball joint vertical play:
      0 mm (0 in.)

      If there is any play, replace the ball joint.

  1. Check the dust cover for damage.


4. INSPECT DRIVE SHAFT BOOTS
  1. Check the drive shaft boots for loose clamps, grease leakage, kinks or damage.


5. INSPECT AUTOMATIC TRANSMISSION FLUID
Type
See Procedures
A343F
Click here
A750F
Click here

6. REPLACE AUTOMATIC TRANSMISSION FLUID
  1. A750F:
    Replace the automatic transmission fluid (Click here).

  1. A343F:

    1. Drain automatic transmission fluid (Click here).

    2. Add automatic transmission fluid (Click here).

    3. Inspect the automatic transmission fluid (Click here).


7. INSPECT MANUAL TRANSMISSION OIL
Type
See Procedures
G52F
Click here
R150F
Click here
RA61F
Click here

8. REPLACE MANUAL TRANSMISSION OIL
Type
See Procedures
G52F
Click here
R150F
Click here
RA61F
Click here

9. INSPECT TRANSFER OIL
  1. Inspect the transfer oil (Click here).


10. REPLACE TRANSFER OIL
  1. Replace the transfer oil (Click here).


11. INSPECT FRONT DIFFERENTIAL OIL
  1. Inspect the front differential oil (Click here).


12. INSPECT REAR DIFFERENTIAL OIL
  1. Inspect the rear differential oil (Click here).


13. REPLACE FRONT DIFFERENTIAL OIL
  1. Replace the front differential oil (Click here).


14. REPLACE REAR DIFFERENTIAL OIL
  1. Replace the rear differential oil (Click here).


15. INSPECT FRONT AND REAR SUSPENSION
Type
See Procedures
Front
Click here
Rear
Click here

16. LUBRICATE PROPELLER SHAFT AND TIGHTEN BOLTS
  1. Lubricate the propeller shaft by referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting.

    Type
    See procedures
    for Front Propeller Shaft
    Click here
    for Rear Propeller Shaft
    Click here

  1. Tighten the bolts of the propeller shaft.

    Type
    See procedures
    for Front Propeller Shaft
    Click here
    for Rear Propeller Shaft
    Click here

← GENERAL MAINTENANCE (from Aug 2013)GENERAL MAINTENANCE (from Aug 2013) →