Home › General › MAINTENANCE › CHASSIS › 2015.06–2020.08
RM27T0E _V1 General _053655 MAINTENANCE _0260401 CHASSIS N

MAINTENANCE  CHASSIS  GENERAL MAINTENANCE  


PROCEDURE

Hide 1.INSPECT POWER STEERING FLUID LEVEL

Type See Procedures
for 1GR-FE (Click here)
for 1KD-FTV (Click here)
for 1GD-FTV (Click here)
for 5L-E (Click here)
for 2TR-FE (Click here)

Hide 2.INSPECT STEERING LINKAGE AND GEAR HOUSING

a.

Check the steering wheel free play (See page Steering>STEERING COLUMN>STEERING SYSTEM>ON-VEHICLE INSPECTION).


b.

Check the steering linkage for looseness or damage.

i.

Check that the tie rod ends do not have excessive play.


ii.

Check that the dust seals and boots are not damaged.


iii.

Check that the boot clamps are not loose.


iv.

Check that the steering gear housing is not damaged.


v.

Check that the connectors are properly connected to the steering gear housing.



Hide 3.INSPECT BALL JOINT AND DUST COVER

a.

Inspect the ball joints for excessive looseness.

i.

Jack up the front of the vehicle and place wooden blocks with a height of 180 to 200 mm (7.09 to 7.87 in.) under the front tires.


ii.

Lower the vehicle until the front coil spring has about half its ordinary load. Place stands under the vehicle for safety.


iii.

Check that the front wheels are pointing straight ahead. Use wheel chocks on all 4 wheels.


iv.

Using a lever, pry up the end of the lower arm. Check the amount of play.

Maximum ball joint vertical play:

0 mm (0 in.)


If there is any play, replace the ball joint.



b.

Check the dust cover for damage.


Hide 4.INSPECT DRIVE SHAFT BOOTS

a.

Check the drive shaft boots for loose clamps, grease leakage, kinks or damage.


Hide 5.INSPECT AUTOMATIC TRANSMISSION FLUID

Type See Procedures
A750F (Click here)
AC60F (Click here)

Hide 6.REPLACE AUTOMATIC TRANSMISSION FLUID

Type See Procedures
A750F (Click here)
AC60F (Click here)

Hide 7.INSPECT MANUAL TRANSMISSION OIL

Type See Procedures
G52F (Click here)
R150F (Click here)
RA61F (Click here)

Hide 8.REPLACE MANUAL TRANSMISSION OIL

Type See Procedures
G52F (Click here)
R150F (Click here)
RA61F (Click here)

Hide 9.INSPECT AUTOMATIC TRANSMISSION FLUID COOLER HOSE AND CONNECTIONS (AC60F)

a.

Check the automatic transmission fluid cooler hoses (No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose) for cracks, leakage, loose connections and deformation.


Hide 10.INSPECT TRANSFER OIL

Hide 11.REPLACE TRANSFER OIL

Hide 12.INSPECT FRONT DIFFERENTIAL OIL

a.

Inspect the front differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 13.INSPECT REAR DIFFERENTIAL OIL

a.

Inspect the rear differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 14.REPLACE FRONT DIFFERENTIAL OIL

a.

Replace the front differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 15.REPLACE REAR DIFFERENTIAL OIL

a.

Replace the rear differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 16.INSPECT FRONT AND REAR SUSPENSION

Type See Procedures
Front (Click here)
Rear (Click here)

Hide 17. LUBRICATE PROPELLER SHAFT AND TIGHTEN BOLTS

a.

Lubricate the propeller shaft by referring to the lubrication chart. Before pumping in grease, wipe off any mud and dust on the grease fitting.

Type See procedures
for Front Propeller Shaft (Click here)
for Rear Propeller Shaft (Click here)


b.

Tighten the bolts of the propeller shaft.

Type See procedures
for Front Propeller Shaft (Click here)
for Rear Propeller Shaft (Click here)