Home › Engine / Hybrid System › 1KD-FTV (FUEL) › COMMON RAIL › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053669 1KD-FTV FUEL _0260568 COMMON RAIL A

1KD-FTV FUEL  COMMON RAIL  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 25800 2.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY (w/ EGR System)

a.

Remove the electric EGR control valve assembly (See page Engine / Hybrid System>1KD-FTV (EMISSION CONTROL)>EGR VALVE>REMOVAL).


Hide 87245A 3.DISCONNECT INLET HEATER WATER HOSE (w/o EGR System)

Hide 25709E 4.DISCONNECT NO. 4 VACUUM TRANSMITTING PIPE SUB-ASSEMBLY (w/o EGR System)

Hide 17113E 5.REMOVE NO. 1 INTAKE PIPE (w/o EGR System)

Hide 22267A 6.REMOVE THROTTLE BODY BRACKET (w/o EGR System)

Hide 23701 7.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY (w/o EGR System)

Hide 17871A 8.REMOVE AIR CONNECTOR STAY (w/o EGR System)

Hide 9.DISCONNECT ENGINE WIRE (w/o EGR System)

Hide 26100G 10.REMOVE INTAKE AIR CONNECTOR WITH DIESEL THROTTLE BODY ASSEMBLY (w/o EGR System)

Hide 17118 11.REMOVE MANIFOLD STAY WITH VACUUM SWITCHING VALVE

Hide 23704 14.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 23770 15.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY

a.
A152742E02
2.635,0.198 2.74,0.198 2.74,0.198 3.167,0.75 true 2.427,0.115 2.615,0.385 0.188,0.271 10 true *1

Disconnect the 3 fuel hoses.


b.

Remove the union bolt, 4 bolts, No. 2 nozzle leakage pipe and gasket.

Text in Illustration
*1 Union Bolt


Hide 23804C 16.REMOVE FUEL INLET PIPE SUB-ASSEMBLY

Hide 23810A 17.REMOVE COMMON RAIL ASSEMBLY

a.

Disconnect the fuel pressure sensor connector and pressure discharge valve connector.


b.
A152743

Remove the 2 bolts, common rail and No. 2 intake manifold insulator.

NOTICE:

Do not remove the pressure discharge valve and fuel pressure sensor.