Home › Engine / Hybrid System › 1KD-FTV (LUBRICATION) › ENGINE OIL COOLER › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053689 1KD-FTV LUBRICATION _0260701 ENGINE OIL COOLER A

1KD-FTV LUBRICATION  ENGINE OIL COOLER  REMOVAL  


PROCEDURE

Hide 51405A 2.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 28100 5.REMOVE STARTER ASSEMBLY

a.

for 2.2 kW Type:

Remove the starter (See page Engine / Hybrid System>1KD-FTV (STARTING)>STARTER (for 2.2 kW Type)>REMOVAL).


b.

for 2.7 kW Type:

Remove the starter (See page Engine / Hybrid System>1KD-FTV (STARTING)>STARTER (for 2.7 kW Type)>REMOVAL).


c.

for 3.0 kW Type:

Remove the starter (See page Engine / Hybrid System>1KD-FTV (STARTING)>STARTER (for 3.0 kW Type)>REMOVAL).


Hide 23810A 6.REMOVE COMMON RAIL ASSEMBLY

a.

Hide 22100 7.REMOVE SUPPLY PUMP ASSEMBLY

Hide 16267 9.DISCONNECT NO. 3 WATER BY-PASS HOSE (w/ EGR Cooler)

a.
A224153

Disconnect the No. 3 water by-pass hose.


Hide 15701C 11.REMOVE OIL COOLER COVER SUB-ASSEMBLY

a.

Disconnect the oil pressure switch connector.


b.

Disconnect the vinyl tube.


c.
A224154

Remove the 2 nuts and disconnect the No. 2 vacuum transmitting pipe from the oil cooler cover.


d.
A224155

Remove the 13 bolts and oil cooler cover.


Hide 15710 12.REMOVE OIL COOLER ASSEMBLY

a.
A224157

Loosen the 4 nuts.


b.

Partially tap out the oil cooler by tapping each nut head with a plastic-faced hammer.


c.

Remove the 4 nuts, oil cooler and 2 gaskets.