Refer to DTCs C1421, C1423 and C1424 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C1421).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1422 | When the stop light switch is off, the PMC terminal voltage is higher than 0.86 V for 5 seconds or more while the vehicle is being driven at a speed of 3 km/h (2mph) or more. | ·
STOP fuse ·
Stop light switch assembly ·
Stop light switch circuit ·
Master cylinder pressure sensor circuit ·
Brake actuator assembly (Master cylinder pressure sensor) |
Refer to DTC C1425 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C1425).
When replacing the skid control ECU (brake actuator assembly), perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When DTC C1425 is output together with DTC C1422, inspect and repair the trouble areas indicated by DTC C1425 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C1425).
OK
NG
Turn the ignition switch off.
Check the brake pedal height and stop light switch assembly installation (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for Vacuum Brake Booster)>ADJUSTMENT).
The brake pedal height and stop light switch assembly installation are normal.
OK
NG
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more and perform a braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1422 is not output | A |
| DTC C1422 is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Make sure that there is no looseness in the locking part and connecting part of the connectors.
Disconnect the A85 stop light switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A85-1(B) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector
(to Stop Light Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A85-3 (GND) - Body ground | Always | Below 1 Ω |
OK
NG
OK
NG
Disconnect the A85 stop light switch assembly connector.
Disconnect the A6 skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A85-2 (L) - A6-2 (STP) | Always | Below 1 Ω |
| A85-2 (L) or A6-2 (STP) - Body ground | Always | 10 kΩ or higher |
OK
NG