A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for LHD vehicles.
89111
1.INSTALL NETWORK GATEWAY ECU
Attach the 2 claws to install the network gateway ECU to the ECU integration box RH.
82877
2.INSTALL ECU INTEGRATION BOX RH
Install the ECU integration box RH with the 2 nuts and bolt.
Attach the harness clamp.
Connect the connectors.
Do not twist the connectors of ECU when connecting them.
Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.
87201B
3.INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
55550
4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
55461A
5.INSTALL INSTRUMENT PANEL ORNAMENT
55317A
6.INSTALL INSTRUMENT SIDE PANEL RH
55607
7.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62111C
8.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure described for the LH side.
for 5 Door: (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>INSTALLATION)
for 3 Door: (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 3 Door)>INSTALLATION)
67910
9.INSTALL DOOR SCUFF PLATE ASSEMBLY RH
Use the same procedure described for the LH side.
for 5 Door: (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 5 Door)>INSTALLATION)
for 3 Door: (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for 3 Door)>INSTALLATION)
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).