Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY RH
for Manual Seat:
Remove the front seat RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL).
for Power Seat:
Remove the front seat RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL).
for Bench Seat Type:
Remove the front seat RH (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>REMOVAL).
72525A
2.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (for Manual Seat)
3.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH (for Bench Seat Type)
84921B
4.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for Power Seat)
84921A
5.REMOVE RECLINING POWER SEAT SWITCH KNOB (for Power Seat)
71811D
6.REMOVE FRONT SEAT CUSHION SHIELD RH (for Manual Seat)
7.REMOVE FRONT SEAT CUSHION SHIELD RH (for Bench Seat Type)
71811D
8.REMOVE FRONT SEAT CUSHION SHIELD RH (for Power Seat)
71861
9.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Separate Seat Type)
73230
10.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Separate Seat Type)
73240
11.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Bench Seat Type)
12.REMOVE FRONT SEAT CUSHION COVER WITH PAD (for Separate Seat Type)
13.REMOVE FRONT SEAT CUSHION COVER WITH PAD (for Bench Seat Type)
71511S
14.REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR) (for Separate Seat Type)
Type A:
Remove the hog rings and disconnect the straps.
Type B:
Cut off the tack pins and disconnect the straps.
| *1 | Tack Pin |
Remove the hog rings and separate type front seat cushion pad (occupant detection sensor) from the seat cushion cover.
15.REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR) (for Bench Seat Type)
Remove the hog rings.
Detach the hook.
| *1 | Hog Ring |
| *2 | Hook |
Cut off the tack pin.
| *1 | Tack Pin |
Remove the hog rings and separate type front seat cushion pad from the separate type front seat cushion cover.