Home › Vehicle Interior › HEATING / AIR CONDITIONING › VISCOUS HEATER MAGNET CLUTCH (for 1GD-FTV) › 2015.06–2018.06
RM27T0E _58 Vehicle Interior _053739 HEATING / AIR CONDITIONING _0261202 VISCOUS HEATER MAGNET CLUTCH(for 1GD-FTV) A

HEATING / AIR CONDITIONING  VISCOUS HEATER MAGNET CLUTCH(for 1GD-FTV)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Cold Area)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 53292A 2.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 82123 5.REMOVE NO. 3 ENGINE WIRE (for Cold Area)

Hide 16571C 6.REMOVE NO. 1 RADIATOR HOSE

Hide 16572D 8.REMOVE NO. 2 RADIATOR HOSE

Hide 17341K 9.REMOVE NO. 1 INTERCOOLER AIR HOSE

Hide 16470 10.REMOVE RADIATOR RESERVE TANK ASSEMBLY

Hide 11.DISCONNECT OIL COOLER HOSE (for Automatic Transmission)

Hide 88359 12.REMOVE VISCOUS HEATER V BELT

a.

Remove the viscous heater V belt (See page Engine / Hybrid System>1GD-FTV (ENGINE MECHANICAL)>DRIVE BELT>REMOVAL).


Hide 14.DISCONNECT HEATER WATER OUTLET HOSE

E321812

a.

Remove the bolt and disconnect the water hose sub-assembly.


b.
E321813

Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water outlet hose.

NOTICE:
·

Do not apply excessive force to the water hose and heater water outlet hose.

·

Prepare a drain pan or cloth in case the coolant leaks.




Hide 15.DISCONNECT HEATER WATER INLET HOSE

E321814

a.

Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water inlet hose.

NOTICE:
·

Do not apply excessive force to the water hose and heater water inlet hose.

·

Prepare a drain pan or cloth in case the coolant leaks.




Hide 87120G 16.REMOVE VISCOUS HEATER WITH MAGNET CLUTCH ASSEMBLY

a.

Disconnect the viscous heater connector.


b.
E321815

Remove the 2 bolts and viscous heater with magnet clutch assembly.