Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › 2015.06–2017.08
RM27T0E _59 Vehicle Exterior _053742 WINDOW / GLASS _0261225 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Rear Power Window RH does not Operate with Rear Power Window Switch RH  


DESCRIPTION

When the ignition switch is ON, the rear power window regulator motor assembly RH is operated by the rear power window regulator switch assembly (for Rear RH Door). The rear power window regulator motor assembly RH has motor, regulator and ECU functions.


WIRING DIAGRAM

B449855E03
0.479,6.427 2.479,6.625 2,0.198 10 false : LIN Communication Line 1.75,1 4.917,1.198 3.167,0.198 10 false Main Body ECU (Multiplex Network Body ECU) 2.833,4.833 4.75,5.25 1.917,0.417 10 false Rear Power Window Regulator Switch Assembly RH 5.083,4.833 7,5.25 1.917,0.417 10 false Rear Power Window Regulator Motor Assembly RH 1.021,1.5 2.021,1.698 1,0.198 10 false from Battery 2.833,4.635 3.833,4.833 1,0.198 10 false L2 5.083,4.635 5.698,4.833 0.615,0.198 10 false L4 3.333,4.052 3.792,4.25 0.458,0.198 10 false GND 5.646,2.188 6.104,2.385 0.458,0.198 10 false GND 2.708,1.677 3.469,1.875 0.76,0.198 10 false DOOR RR 3.792,3.583 4.406,3.781 0.615,0.198 10 false DOWN 5.656,3.583 6.271,3.781 0.615,0.198 10 false DOWN 4.042,2.969 4.354,3.167 0.313,0.198 10 false UP 5.656,2.969 5.969,3.167 0.313,0.198 10 false UP 5.656,1.5 5.813,1.698 0.156,0.198 10 false B 4.396,3.469 4.552,3.667 0.156,0.198 10 false 7 5.438,3.469 5.594,3.667 0.156,0.198 10 false 7 4.396,2.844 4.552,3.042 0.156,0.198 10 false 6 5.354,2.844 5.604,3.042 0.25,0.198 10 false 10 5.417,2.063 5.573,2.26 0.156,0.198 10 false 1 3.094,3.917 3.25,4.115 0.156,0.198 10 false 1 5.417,1.385 5.573,1.583 0.156,0.198 10 false 2

CAUTION / NOTICE / HINT

NOTICE:
·

The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

·

If the rear power window regulator motor assembly RH has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).

·

Check that the window lock switch is off before performing the following procedure.

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.READ VALUE USING GTS (MAIN BODY)
a.

Read the Data List according to the display on the GTS (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Communication RRDoor Motor Connection status between rear power window regulator motor assembly RH and main body ECU (multiplex network body ECU) / STOP or OK STOP: Communication stopped
OK: Normal communication
-

OK:

On the GTS screen, OK is displayed.




OK

2.READ VALUE USING GTS (RR-DOOR MOTOR)

NG

2.READ VALUE USING GTS (RR-DOOR MOTOR)
a.

Read the Data List according to the display on the GTS (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

RR-Door Motor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RR Door P/W Up SW Rear RH door power window manual up switch signal / OFF or ON OFF: Rear RH door power window manual up switch not being operated
ON: Rear RH door power window manual up switch being operated
-
RR Door P/W Down SW Rear RH door power window manual down switch signal / OFF or ON OFF: Rear RH door power window manual down switch not being operated
ON: Rear RH door power window manual down switch being operated
-

OK:

On the GTS screen, ON or OFF is displayed accordingly.




OK

3.PERFORM ACTIVE TEST USING GTS (RR-DOOR MOTOR)

NG

4.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
3.PERFORM ACTIVE TEST USING GTS (RR-DOOR MOTOR)
a.

Perform the Active Test according to the display on the GTS (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

CAUTION:

Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.


RR-Door Motor
Tester Display Test Part Control Range Diagnostic Note
Power Window Power window OFF/UP/DOWN -

HINT:

Up and down movement does not occur if the arrow is not pressed and held.


OK:

Rear RH power window operates normally.




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

4.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
a.

Remove the rear power window regulator switch assembly RH (See page Vehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>REMOVAL).


b.

Inspect the rear power window regulator switch assembly RH (See page Vehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>INSPECTION).



OK

5.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH - REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH)

NG

REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH

5.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH - REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH)
a.

Disconnect the L2 rear power window regulator switch assembly RH connector.


b.

Disconnect the L4 rear power window regulator motor assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L2-6 (UP) - L4-10 (UP) Always Below 1 Ω
L2-7 (DOWN) - L4-7 (DOWN) Always Below 1 Ω
L2-6 (UP) - Body ground Always 10 kΩ or higher
L2-7 (DOWN) - Body ground Always 10 kΩ or higher




OK

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR