Home › Suspension › SUSPENSION CONTROL › AIR SUSPENSION SYSTEM › from 2017.08
RM27T0E _53 Suspension _053706 SUSPENSION CONTROL _0260870 AIR SUSPENSION SYSTEM C

SUSPENSION CONTROL  AIR SUSPENSION SYSTEM  C1762  Continuous Current to Exhaust Solenoid  


DESCRIPTION

The exhaust valve built into the height control compressor assembly opens to discharge compressed air from the pneumatic cylinders into the atmosphere according to the signal from the suspension control ECU.

DTC Code DTC Detection Condition Trouble Area
C1762 With the exhaust solenoid valve activated, the vehicle height is not lowered to the standard vehicle height after 100 seconds have elapsed.
·

Clogging in air tube or each valve

·

Leveling solenoid valve (No. 2 height control valve)

·

Gate solenoid valve (No. 2 height control valve)

·

Exhaust valve (Height control compressor)

·

Suspension control ECU



CAUTION / NOTICE / HINT

NOTICE:

When replacing the suspension control ECU, perform registration (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>REGISTRATION).


HINT:

If DTC C1782 is output at the same time, perform troubleshooting for C1782 first (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>C1782).


PROCEDURE

1.CUSTOMER PROBLEM ANALYSIS
a.

Ask the customer about the vehicle and usage conditions when the DTC was stored.

HINT:

DTC C1762 can be stored under unusual vehicle or usage conditions.

Points to confirm
·

Confirm if there were any foreign objects caught between the body and tires.

·

Confirm if the vehicle has been driven on an unpaved surface or with a wheel not contacting the ground.

·

Confirm if the vehicle height mode has been continuously changed using the height control switch, causing the vehicle to raise and lower repeatedly.






NEXT

2.CHECK DTC
2.CHECK DTC

b.

Start the engine and wait for 100 seconds or more.


c.

Set the vehicle height to HI, wait until the vehicle height change is complete, and then return the vehicle height to normal.


d.

Check for DTC (See page Suspension>SUSPENSION CONTROL>AIR SUSPENSION SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC C1762 is output A
DTC C1762 is not output B
DTC C1762 and other DTCs are output C



A

3.INSPECT AIR TUBE (AIR TUBE FOR CLOG)

B

END (C1762 WAS OUTPUT DUE TO UNUSUAL VEHICLE OR USAGE CONDITION)

C

3.INSPECT AIR TUBE (AIR TUBE FOR CLOG)
a.

Inspect the air tubes for clogs (See page Suspension>SUSPENSION CONTROL>SUSPENSION CONTROL SYSTEM (w/ Air Suspension)>PRECAUTION).

OK:

No clogs are found in the air tubes.




OK

4.INSPECT NO. 2 HEIGHT CONTROL VALVE

NG

REPAIR OR REPLACE AIR TUBE

4.INSPECT NO. 2 HEIGHT CONTROL VALVE

OK

5.INSPECT HEIGHT CONTROL COMPRESSOR (EXHAUST SOLENOID VALVE)

NG

REPLACE NO. 2 HEIGHT CONTROL VALVE

5.INSPECT HEIGHT CONTROL COMPRESSOR (EXHAUST SOLENOID VALVE)

OK

REPLACE SUSPENSION CONTROL ECU

NG

REPLACE HEIGHT CONTROL COMPRESSOR ASSEMBLY