Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
If the side airbag was deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
for Manual Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY)
for Power Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY)
for Walk in Seat Type: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Walk in Seat Type)>DISASSEMBLY)
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side. (for Manual Seat, Power Seat)
The procedure listed below is for the RH side. (for Walk in Seat Type)
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
71910A
3.REMOVE FRONT SEAT HEADREST ASSEMBLY
for Manual Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL)
for Power Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL)
for Walk in Seat Type: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Walk in Seat Type)>REMOVAL)
72128A
4.REMOVE FRONT SEAT INNER TRACK BRACKET COVER LH
for Manual Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL)
for Power Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL)
72124
5.REMOVE FRONT SEAT OUTER TRACK BRACKET COVER LH
for Manual Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL)
for Power Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL)
72158
6.REMOVE INNER SEAT TRACK BRACKET COVER LH
for Manual Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL)
for Power Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL)
72138B
7.REMOVE SEAT TRACK COVER LH
for Manual Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL)
for Power Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL)
72127A
8.REMOVE FRONT SEAT INNER TRACK BRACKET COVER RH (for Walk in Seat Type)
72123A
9.REMOVE FRONT SEAT OUTER TRACK BRACKET COVER RH (for Walk in Seat Type)
72157A
10.REMOVE INNER SEAT TRACK BRACKET COVER RH (for Walk in Seat Type)
72137B
11.REMOVE SEAT TRACK COVER RH (for Walk in Seat Type)
12.REMOVE FRONT SEAT ASSEMBLY
for Manual Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL)
for Power Seat: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL)
for Walk in Seat Type: (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Walk in Seat Type)>REMOVAL)
71706
13.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)
71706B
14.REMOVE FRONT SEATBACK BOARD CLIP (w/ Seatback Board)
73920A
15.DISCONNECT FRONT SEAT SIDE AIRBAG ASSEMBLY
w/o Seatback Board:
Remove the rubber band from the seat cushion spring.
for Manual Seat, Power Seat:
Detach the claw and disconnect the airbag connector.
| *1 | Fastening Tape |
Detach the 3 airbag wire harness clamps.
Detach the fastening tape and open the cover.
Disconnect the airbag wire harness.
for Walk in Seat Type:
Remove the rubber band from the seat cushion spring.
Detach the claw and disconnect the airbag connector.
| *1 | Fastening Tape |
Detach the 4 airbag wire harness clamps.
Detach the fastening tape and open the cover.
Disconnect the airbag wire harness.
16.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Use the same procedure for the RH and LH sides.
w/ Seat Heater System:
Disconnect the seat heater connector and detach the wire harness clamp.
w/o Seatback Board:
Remove the 3 hog rings.
Open the 2 fasteners, and then open the front seatback cover.
| *A | for Cloth Seat | *B | for Leather Seat |
w/ Seatback Board:
Detach the hooks.
Remove the 5 hog rings.
Remove the nut and front seatback cover bracket.
Using a screwdriver, detach the 4 claws to remove the 2 front seat headrest supports.
Remove the separate type seatback cover with pad.
73920A
17.REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY
When storing the front seat side airbag assembly, keep the airbag deployment side facing upward.
Use the same procedure for the RH and LH sides.
Detach the 2 clamps.
Remove the 2 nuts and front seat side airbag assembly.
The nuts must not be reused.
Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.