12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Urea SCR System)
2. PRECAUTION (for Cold Area)
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Cold Area)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
53292A
4.REMOVE UPPER RADIATOR SUPPORT SEAL
52129B
5.REMOVE FRONT BUMPER LOWER COVER
51405A
6.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
7.DRAIN ENGINE COOLANT
8.DRAIN ENGINE COOLANT (w/ Urea SCR System)
82123
9.REMOVE NO. 3 ENGINE WIRE (for Cold Area)
16571C
10.REMOVE NO. 1 RADIATOR HOSE
17342F
11.REMOVE NO. 2 INTERCOOLER AIR HOSE (w/o Urea SCR System)
16572D
12.REMOVE NO. 2 RADIATOR HOSE (w/o Urea SCR System)
17341K
13.REMOVE INTERCOOLER AIR HOSE (w/o Urea SCR System)
161B0
14.REMOVE ELECTRIC WATER PUMP ASSEMBLY (w/ Urea SCR System)
16640
15.REMOVE INTERCOOLER RESERVOIR ASSEMBLY (w/ Urea SCR System)
Detach the clamp.
Move the hose clip and disconnect the No. 4 sub radiator hose.
Do not apply excessive force to the No. 4 sub radiator hose.
Prepare a dish to collect any coolant that leaks.
Detach the clamp.
Remove the 3 bolts and intercooler reservoir assembly.
16553B
16.DISCONNECT NO. 3 SUB RADIATOR HOSE (w/ Urea SCR System)
Detach the clamp and disconnect the No. 3 sub radiator hose.
16470
17.REMOVE RADIATOR RESERVOIR ASSEMBLY
18.DISCONNECT OIL COOLER HOSE (for Automatic Transmission)
88359
19.REMOVE VISCOUS HEATER V BELT
16711
20.REMOVE FAN SHROUD
21.DISCONNECT HEATER WATER OUTLET HOSE
Remove the bolt.
Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water outlet hose.
Do not apply excessive force to the heater water outlet hose.
Prepare a drain pan or cloth in case the coolant leaks.
22.DISCONNECT HEATER WATER INLET HOSE
Using pliers, grip the claws of the clip and slide the clip to disconnect the heater water inlet hose.
Do not apply excessive force to the heater water inlet hose.
Prepare a drain pan or cloth in case the coolant leaks.
87120G
23.REMOVE VISCOUS HEATER WITH MAGNET CLUTCH ASSEMBLY
Disconnect the viscous heater connector.
Remove the 2 bolts and viscous heater with magnet clutch assembly.