Home › Engine / Hybrid System › 2TR-FE (INTAKE / EXHAUST) › INTAKE MANIFOLD › from 2020.08
RM27T0E _51 Engine / Hybrid System _053676 2TR-FE INTAKE / EXHAUST _0260634 INTAKE MANIFOLD A

2TR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 17111 1.INSTALL INTAKE MANIFOLD

a.

Install the purge line hose to the intake manifold, and slide the clip to secure the hose.


b.

Install the 2 wire harness clamp brackets to the intake manifold with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.
A341602

Install the intake manifold insulator to the intake manifold.

HINT:

Insert the protrusions of the intake manifold insulator into the grille of the intake manifold.


NOTICE:
A341603E04
1.594,1.021 1.208,0.719 1.208,0.719 1.01,0.719 false 2.094,0.688 1.719,0.49 1.719,0.49 1.521,0.49 false 1.354,0.375 1.667,0.573 0.313,0.198 10 false *a 0.844,0.625 1.156,0.823 0.313,0.198 10 false *1

Insert the intake manifold insulator until the position of the line as shown in the illustration.

Text in Illustration
*1 Intake Manifold Insulator
*a Line



d.
C213697

Install a new gasket to the intake manifold.


e.

Install the intake manifold with the 5 bolts and 2 nuts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


f.

Install the 2 No. 2 intake manifold insulators to the intake manifold.


g.

Connect the No. 3 ventilation hose to the intake manifold, and slide the clip to secure the hose.


h.

Attach the No. 2 water by-pass hose to the intake manifold.


i.

Attach the 2 wire harness clamps to the 2 wire harness clamp brackets.


Hide 23250 3.INSTALL FUEL DELIVERY PIPE WITH FUEL INJECTOR

Hide 22030 4.INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY

Hide 53737A 6.INSTALL FRONT NO. 1 FENDER APRON TO FRAME SEAL LH

a.

Install the front No. 1 fender apron to frame seal LH with the 5 clips.


Hide 53737B 7.INSTALL FRONT FENDER APRON SEAL LH

a.

Install the front fender apron seal LH with the 5 clips.


Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 9. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART