Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
DESCRIPTION
The glow plug is mounted inside the engine combustion chamber. To ensure efficient engine starting with a cold engine, the ECM calculates a time interval of the current that needs to flow through the glow plug depending on the starting engine coolant temperature when the ignition switch is turned to ON. The ECM then turns on the glow plug relay and permits current to flow through the glow plug based on the ECM calculated time. The glow plug is then heated, and enhances fuel combustion with a cold engine. This DTC will be stored if the glow plug or the circuit is open.
HINT:
These troubleshooting procedures are for: 1) difficult engine starting in cold weather, and 2) difficulty driving/vehicle malfunctions in cold weather immediately after engine is started.
After the engine is started, the ECM performs an "after-glow" for a certain period of time. In proportion to the actual engine coolant temperature, the time period varies. The after-glow reduces diesel engine knocking, white smoke emissions and engine noises when the engine is cold.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
1. CHECK ECM TERMINAL VOLTAGE (GREL TERMINAL)
Remove the GLOW 1 relay from the engine room relay block.
Remove the GLOW 2 relay from the engine room relay block.
Measure the voltage according to the value(s) in the table below.