Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
- If the auto up/down function does not operate, the cause may be one or more of the following:
- The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.
- The master switch has a malfunction.
- The Hall-IC in the driver side power window regulator motor has a malfunction.
- There is an open or short in the wiring between the master switch and the driver side power window regulator motor.
INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Check for DTCs (Click here).
Result Result
Proceed to
DTC is not output
A
B2311 is output
B
B2312 is output
C
B2313 is output
D
LIN communication system DTCs are output
E
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | |
| 2. CHECK MANUAL UP/DOWN FUNCTION |
Check that the driver side door power window moves when the manual up/down function of the multiplex network master switch is operated (Click here).
- OK:
- Driver side door power window moves.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER (MULTIPLEX NETWORK MASTER SWITCH) |
Use the Data List to check if the master switch is functioning properly (Click here).
Master Switch Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D Door P/W Auto SW
Driver side power window auto up/down signal / ON or OFF
ON: Driver side power window auto up/down switch operated
OFF: Driver side power window switch not operated
-
- OK:
- The display changes according to operation of the multiplex network master switch.
Result Result
Proceed to
NG
A
OK (for LHD)
B
OK (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
